What Have You Done To Your 3rd Gen Today?

cool thx

 

Pretty noticeable. Almost need one for the other side

 

How did you get that much mud in there?

 

Can u not get a k&n with a dry filter?

 

Driving

I live a mile and a half from pavement. My road is either really dusty or really muddy depending on the rain.

Plus i off-road often.

No idea sorry. I didn't care for the k&n exposed filter design so i didn't look at them.


I also like the aFe, but it was more than $100+ over the price of the s&b.

 

I was going to reply and correct your correction.. But it looks like a couple others have already done that.

In this case, your $.02 is worth $.00.

 

New wheels should only cost you net ~$300. I got my sema wheels for $800 and sold my sport wheels for $500.

 

I do always forget that whole selling the original ones part... Maybe I'll keep my eye out a bit more for a good sale.

 

https://sandiego.craigslist.org/csd/pts/6184134853.html shit crazy why did I buy new truck haha could just got this lol

 

Ok yes, y'all are right. It won't affect the hub which is controlled by the suspension. Changing tires will affect the SAI and tire scrub when turning, not enough to require an alignment, but enough to alter the specs slightly. If I spent a bunch of money on new wheels and tires I would wanna make sure they won't have premature where. Doing an alignment would ensure consistent drive quality.

 

I second that. Don't ever go to Mossy Toyota either. Kearny or Carlsbad are the best.

 

Undercover ridgelander, pioneer platform, (loaded up), and ajt key fob

 

Oh ya that makes sense then!

And oh ya I'm curious I want a new intake to get rid of that lag

 

I'm guessing i should have the S&B cold air intake around the end of the week. I'll install it same day and give an honest opinion on it.

 

My open K&N is great for my rear wheel drive pavement princess truck. I figure the 1st time I remove and clean it I will decide whether or not to fabricate a screen cover for the top. After 7.5 months all is fine. I can see why an off-roader would not want an open breather of any kind. That would be nothing but trouble.

 

I had a setup like that, with a sheet of 3/4" plywood and a foam mattress over the wheel wells and supports in a Toyota 4-wd truck with a tall camper top in the early 80's. Great for camping trips across and all over mountain wilderness areas of US & Canada. Our cooler and tent & cooking & camping gear lived in crates slid under the plywood, even had it screened so if we slept onboard we'd survive the mosquitos.

 

How is the sunshade holding up? Does it stay in place even after it gets hot?

 

I will PM you some photos later on it sits pretty flush though. I sometimes forget I even have it.

 

Tomorrow I will be replacing these two pita led lights on brushgaurd with a 30in Rough country black edition. The pia lights were a waste of a switch.

 

Helped a friend move all weekend. Truck handled the trailer better than I expected. Used s4-5 with ect the whole time.