Raleigh North Carolina and surrounding areas

There are a few places that will put it on, but I personally have never used them. 0.00 in labor, except powdercoat. I'm in hampstead and willing to assist if your down to get the knuckles dirty mom !

 

Anyone around hickory, NC with a planned trip between here and wilmington?

 

Only kale buddy

 

What's up with the needle bearings? I'd that a 3rd gen thing?

 

Purchased a large amount of these from my local health store for next mod day to share with everyone

 

Yeah. It's correct a common vibration problem after lifting 3rd gens. I just went ahead and bought it so I don't have to mess with it later

 

Is it to replace the bearing on the clamshell? Or different location

 

Yep, turtles on the half shell

 

I may be planning an "install lift party" soon if anyone would like to attend.

Still trying to figure out what size tire I want but I have everything else.

Beer and pizza is on me of course.

 

turtle power

 

Ill have a used set of dirty5's this week

 

Some fancy shit for sale in here
https://www.tacomaworld.com/threads/garage-sale.498995/

 

https://www.tacomaworld.com/threads/garage-sale.498995/

retros and flares are sold, there is a good deal on a bumper for those with a white taco!! check it out

 

I think that's a little bigger than I want to go. I'm thinking either 285/75R17 or 295/70R17, but I'm leaning towards 295's.

 

I was worried I'd have to cut with my 285/75s but i got lucky. Might not be the case when I throw those spidertraxs

 

It's going to be a downward spiral, them you will want bigger flares do truck won't always be dirty

 

So 4 wheel parts is a good spot to go for lift install?

 

Don't have to with LT

 

Nope self