What Have You Done To Your 3rd Gen Today?

Rago Fabrications makes them as well - there was a group buy here a month back. No cut - 20 minute install.

I haven't mounted them yet, but it's on the list to get done in the next few weeks.

 

3" lift

 

Looks freaking sweet; where did you get the stripes?

 

Hey all, I got a lot of ideas from seeing what everyone else has done on this forum, and here's what I've done to my Tacoma so far.

 

Welcome to the forums! Truck is looking sharp!

 

Cool!

 

Thanks everyone!

 

A couple of quick tweaks done today.

I replaced the yellow Baja Squadron Sport covers with actual yellow lenses. Converted the beam from "wide cornering" to "driving combo". Looking forward to seeing the difference tonight.


Rerouted the exhaust. Finally! I've had mid and rear skids sitting in my garage for a couple of months... I've been delaying that install since I'm fairly certain I'll have to take the sliders off to cut some notches in them for the rear skid to sit flush against the frame. Fun fun!

 

Are you planning to put a heat shield on to protect the transfer case?

 

No, but I'll keep an eye on things. I haven't heard of any issues with this approach, have you?

 

I've heard of people putting a wrap or heatshield on since its much closer to the transfer case.

 

Let us know what you think about the difference in the two lenses please. Those are the two I'm trying to decide between. I have it down to go with the Driving/Combo route but would love to hear your feedback with the comparison of the Wide Cornering.

 

Damn you...NICE!!!!

 

I joined the dark-side and installed the Pro grill.

 

Where are you installing the Xbox One controller? Back seat entertainment system?

 

Thanks. 1060 Graphics website for the vinyl stripe. I had them lay it on transfer paper and weed it, ready to apply. Their website has an ordering template and sample designs.
I designed the stripes by drawing it out full width on graph paper, and moving it around till it felt right. The gaps wanted to be a bit narrower than the stripes.
Pinstripes are a 3m tape product on transfer tape.

 

N-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o-o. Traitor.

 

Props to @eccracer104 for the hookup!
Just need to finish up some cutting and grinding before the 35's will fit