What Have You Done To Your 2nd Gen Tacoma Today?

Yes I wish they did that for all motors. My Girlfriends old tundra you had to remove the front skid plate to change the filter it was a PITA

 

I'm sending you lots of speedy recovery thoughts!!

 

Perhaps a local member needs a nice new rear bumper? You should be able to get most of your money back and then get the swing-out you NEED!

 

Hey Nuno! Welcome back ! Trust you had a good time and everything went well

 

Welcome back!! Hope yall had a blast!

 

Trimmed the extra long flaps.

 

Just take them off brother! The irony is that now that they are trimmed and look great and are less likely to get ripped off on the trail ... that they will probably not stop your tires from kicking up rocks.

 

I loved it when they were off for the hour or so. I put them back on to see what it looked liked trimmed...But they probably will come off

 

More details please!

 

I cringe a little every time I see a photo of folks welding in short sleeve shirts Good job dude, looks great!

 

Remember Charlie.

 

Got my rock slider project completed and welded on. I picked up the materials, 2" square tubing, 2" round tubing and some 2" flat steel. Gave it all to a fabricator friend of mine an he put it all together. It turned our better than expected.

 

I regret not wearing long sleeves even though it was 90+ outside

 

Installed some flush mount rear lights. More of a necessity than ascetics. I needed more light back there when I launch my boat for per-sunrise or night time fishing. I wired these as stand alone and only when head lights are on so they do not go on with the reverse lights.

 

Feel the burn.

 

Sure did! Sucks to be back to be honest.

 

Haha!! I know the feeling lol

 

Ditched the fuel trophys for some 2017 OR wheels with a bit smaller tires. love the look. Now just need some spydertraxs to make up for some needed offset.

 

I made the plate at work in my spare time. Its 1/8 stainless, then I laid out my switch pro, terminal block, and ground bar. Drilled those holes and drilled out 3, 7/8 holes. Put rubber grommets in them and will be running all my wiring up through those. The terminal block is a blue sea 30amp 10 space and the ground bar is a 12 terminal block. I ran my harness through the main harness boot on the firewall. Tapped the yellow wire into the green wire on the marker light and the blue wire to the EFI fuse in the fuse box using the add a fuse. Still gotta finish the switch module mounting inside the cab but am putting it in the sunglass holder with a mount from @XPOTRPR . Hopefully this covers everything, if you have anymore questions feel free to ask.