Brake Override Malfunction

Cause the Brake Over ride Malfunction code. Not like I can just keep the car sitting or have an error code. The tail lights I have no idea what else can be done rn.

 

Fuse(s), relay, or ECU

 

According to this diagram, you have 2 fuses to check. Have you checked both of them?

 

Not on a push button. You need to step on the brake to start the truck. Also the brake circuit powers the shift release, so the shifter will also be locked

 

Yup it is locked

 

Gotta be another blown fuse. Just test them or take a closer look

 

Do you have a meter or are you checking them visually?

 

Visual

 

So far only see 1 and I've referred to the diagram

 

Correction I did find the STOP fuse blown in the engine bay fuse box. Battery has been disconnected for a bit about to start it.

 

Good luck. Keep us posted.

 

She starts!!!!!

 

Awesome. It should drive ok now. Take it for a short test drive.

 

No that's it night out I can for sure see what lights are working. So rear tails don't light up at all. Passenger rears does turn signal and brake lights on. Driver side hyper blinks and no lights are on. DRLs are not on at all. HIDS works and front LED dogs work. Did not check the drl fuses.

 

Which lights do you have in the truck. Factory or the aftermarket?

 

The rears are all factory now. Only after market is the front

 

Aftermarket LED's are known to hyper flash. You need a resistor installed to stop that.

 

Even though it's only happening on the rear tails? Only LEDs are the fogs. Rears have none and the headlight is HID. Didn't even put leds in the front turns

 

And to.make sure the power is out. Take the positive and neg. Off. Then touch

So are u back on for the take over?

 

Haha nope. I still gotta make sure it won't happen to me when I'm out there especially on trail I don't want to go into limp mode or have it turnoff. But if they give me a rental