What Have You Done To Your 2nd Gen Tacoma Today?

The easiest place is in the Drivers' A pillar. There is a tiny blue wire in the harness. There are a number of threads about finding it.

 

If you decide to remove it, spray it with WD40. Let sit for a few minutes, wipe right off.

 

Place your can of dip in warm water before you apply. Spays more evenly and will dry more smoothly.

 

This happened to my grill surround when I plastidip it white in 0% humidity. From my research, it could also be the distance you are applying it. I.E too far away.

 

Lol you don't need any products to remove it if it's applied correctly. It will come off all in one sheet.

 

Well I just stripped one of the bed bolts...anyone know wtf I do now to get it to come up?

 

Drill it and use a bolt extractor or easy out

 

Can you get a screw driver or pry bar under it to put some upward pressure on it as you continue to try to back it out?

 

If I had someone doing that while I worked the ratchet maybe

 

I did try to stay back because I was afraid it would run.

 

I haven't, but great idea. Today was the first time I got them mounted up. Guess I need to go buy a level lol

Thanks!

 

Not sure what I'm looking at, but I only see "likes received"

 

PM tcbob with your address and ask nicely and one should show up.

 

Or a pickle fork. That would be easier.

 

Blow torch!

 

Sounds a bit extreme lol

 

Go big or go home. Worst case scenario you have the bed drain plug mod!

 

That's a good point. Bed drain plug mod doesn't sound so bad lol

 

Flexed and my stock shackles couldn't handle it.

https://vimeo.com/225784553

 

Well TacomaWorld, here she is. 285/70/17 nitto ridge grapplers with 0 scrubbing on Vin's absolutely kick ass SCS SR8 wheels. Can't wait to get new lights installed too which will clean the front end up a lot. Y'all have no idea how stoked I am! Especially since I ain't gotta do the CMC