What Have You Done To Your 3rd Gen Today?

Beautiful pictures!

 

Added a Rhino-Rack roof rack.

 

Yes, push the camera button and view the back up camera anytime - I have a manual trans, so I can't just put it in reverse driving down the road, like in the automatics. It was available thru a few members on here

 

Sorry to hear about the Ribs Jerry!! I know the take some time to heel, but looks like a fantastic tme other than that! Be careful and enjoy!

 

I don't think the bed length matters, as the cabs are the same. Mine are installed on a 2017 DCSB.

 

After reading hundreds of posts, I should know this but which bumper is that?

 

The large, gaudy door badges on the Pro are super hard to get off. I tried the fishing line method with no luck. I couldn't even pry the corners up with my fingernails. Want to get them off asap before fading; truck has been sitting outside for 4 months. Going to try again with a hair blow dryer next. Any tips? A soak?

 

Southern Style Offroad

 

The cab lengths are the same but the dclb OEM tube steps extend past the cab to the wheel wells. I'm sure they'll still fit but aesthetically it might look "off"
My OEM tube steps:

 

What makes you think you can put an automatic trans in reverse while driving down the road?

 

This guy tried it. There's even a video if you go to this thread:

https://www.tacomaworld.com/threads/tips-and-tricks-on-the-3rd-gen-tacoma.411911/

Edit: added video

 

Oooh I'd want one!!

 

Hey, has anyone tried hacking the output feed from their backup camera to see the view from the rear view camera on their trailer?

Ok, looked for it and the answer is yes- there are other forums in different sites where people have tried it. Will update when I try it too!​

 

Heat and braided fishing line. Super thin, strong and a little cutting action...just pull a little towards the badge when doing any sawing action.

 

Thanks

 

Use a blow dryer if temp is below 70. Get 40lb test line, wrap the line around two rods, or small blocks of wood( I used two screwdriver handles) to grip the fishing line then saw away.
To get rid of the glue residue you can use WD40. I used a rubber eraser wheel made for debaging, getting rid of residue from Home Depot.

 

How's the wind noise like above 65mph?
I have a ARE Overland top on order with just the rack tracks, Yakima.
Looking at these Rhinos. Read lots of reviews. Many reviews read that they whistle above 40mph.
Otherwise I'll bite the $$$ bullet for the Yakima JetStream racks.
Also what length did you get for the crossbars?
Thanks!

 

I bought my 2015 T4R SR5 brand new for 34k. Right at invoice with entune optioned. I recently went back to a Tacoma. I liked the 4runner, but was sick of the 4.no

 

OK, so it's not going into reverse. Don't think I'd try this even with a fail safe mode.

 

Good looking truck sir.