San Diego BS Thread.

Already tried them earlier but thank you.

 

Blue Tacoma full of blood..

 

Doesn't even phase me anymore when I was searching through the pick and pull parts.

Junk yards are expensive too. It sucks.

 

I'll check I may have one from my 98 2RZ.... I swapped in a V8 so took all the other stuff off, I'll PM you if I find it this afternoon

 

I found what appeared to be brain matter and tissue on a truck (headliner and A pillar) I was looking to get a motor from, guy committed suicide in the truck and they didn't clean it very well! Nasty..didn't take the motor, just seems like bad Juju!!

 

Found one but thank you!!

 

OK I just dug one out this morning. No problem at all buddy.

 

Found some new yellow posts and broke in some new tents.

 

Where at? Looks like a good spot

Nice handle btw. Hahah

 

Thomas mountain south of idyllwild

 

Sweet, looked familiar. Thomas mountain is a nice trail. Haven't camped on it yet however

 

For those with aftermarket UCAs, did you guys get ball joints or uniballs? Are you happy with your decision?

 

Okay so I know it's a super super long shot but figured I would put it out there and see if anyone is interested.

Reason:
I bought a brand new Front runner rack for the cab to match the rear Front runner rack that I already had, but once I got it I realized that they have made some changes to the design of the front rack. The biggest issue was that the racks are now about 49" wide instead of 46" wide. So unfortunately I had to order new cross slats for the rear rack to make the two racks even in width. Now I have the front rack installed and realize that I like the way the older design looked more. The new design sits slightly higher allowing more room for a shark fin antenna (which I don't have). The other benefit to the New design is that it allows you to mount one of the undermount front runner Tables.
This is the new style rails



What I am looking For:
I am looking for someone in Socal area that has a older version rack front and rear in good condition that is the 46" wide version with the cab mounts that look like this.


Just looking to do a swap of both racks if anyone is interested. I know it's a super long shot, but I figured I would put it out there.

 

Is that the trail we ran with Chan in the Spring?

 

Uniball here -
No complaints aside from the uniball starts to get squeaky if you don't lube it every once in awhile.

 

Yeah pretty sure

 

I went with ball joints because when i got them i lived in the south-east and rust is a problem. out here i would probably go with uniballs.

 

How often do you lube it? I am debating on uniballs and ball joints.

 

I have Camburg UCA's with uniballs. I lube them anytime after a wash, after driving through wet terrain, once there is any noise coming from the front end, etc....

 

I hope this isn't one of those "easier said than done" because if it's that simple, I don't see why more people go uniball?