What Have You Done To Your 2nd Gen Tacoma Today?

How much would they cost to have made? And, most important, how much do they weigh?

 

I don't have it in my Tacoma, sorry... It's on my '06 F150. I think you'll be able to use the harness but with some direction

 

The Toyota harness and pigtail worked for my Tekonsha Voyager. This was an older controller that I removed from my old F150 and installed in my Tacoma. Not the latest with all the bells and whistles, but it does the job and I am familiar with it.

 

just use lots of heat and be gentile with the floss it will go a long way

 

Got it back from Sacramento Spring. Put about inch and half to two inches of lift in the rear. Hard to see in pics but in person it looks so much better.
Before:


After:

 

Prodigy P3

 

I wired mine like this (can't actually see my splices because they are tucked up in the dash in wire loom) but after looking at the wiring diagrams for both I am pretty sure this is how I did mine.

Factory pigtail color------------> P3 pigtail
Black with red tracer (thick)------> Black (thick)
Solid Brown----------------------> White
Green w/white tracer-------------> Red
Red (thick)----------------------> Blue (thick)
Solid Green----------------------> Does not connect to P3 pigtail (tape up out of the way)

Hope that helps!

 

Put this together today. Inline regulator and lock-on air chuck. This way, I can hook my solar heater up to my OBA and have pressurized water. $3 for the coil hose at HF, so not much loss if I decide to go with a short regular air hose instead. But for now, it works.

 

You are lucky it happened while it was unlocked. Time to install an emergency release cord in case it happens when it is locked then you can give a quick tug and it will release the lock.

Pop N Lock PL8521 Install With Emergency Release

 

Thanks so much! Did not even consider a worse situation than what I had before...

 

Purchased another Patch for the Headliner. The Mountains are calling.

 

Kinda weird. I'm wearing a t shirt as we speak that says the same.

 

Where did you get it? Linky?

 

Cruisergear.com
It's sold out but you can click on the sold out icon after clicking on the patch on the site for a restock notification..

 

Cleaned my much neglected K&N air filter .... I keep forgetting to clean it.

 

Finally got my Bullet Proof Fabrication Skid Plate and Tow hook mount install. Then i had Some 3/4" shackles in the garage and was able to finally put them to good. use.


Truck all washed up below. But i desperate need of new leaf pack. With no load i hit bump stops on some water drainage ditched in intersections. I also been hitting bump stops with Family camp trips and kids gear. The Kings have always been adjusted a little higher in front for a leveled out stance. but my leaf packs are too soft and with always having the Shell on time for a upgraded leaf packs.

Freshly installed OLD MAN EMU EL095R DAKAR LEAF SPRING SET. I didn't want to be to raked out in back as i don't always carry heavy loads. So i Removed the 3rd leaf down for ride comfort and also still provide a lift to raise my rear about an 1" to bring the sitting level Stoked and rides WAY better than stock leaf while providing more load capacity.
Finally

 

You know I hate it when you people make me spend my monies

https://cruisergearshop.com/collect...for-adventure-fj-keychain?variant=38935243852

 

They took my 2nd gen from me. Won't have it for couple months+ from frame. Damn I miss my 4.0...

 

Is that your rental?