What Have You Done To Your 2nd Gen Tacoma Today?

Installed my DIY shovel and axe mount. Plans worked great @Benson X!

Fits perfect over my fire safety / mix tape storage compartment.

 

I must have had a headache that night.

 

Need a fire extinguisher for that mix tape

 

Heat it up some with a hair dryer and it's even easier

 

Funny enough, that is ACTUALLY what is in there.

 

I did! To the point it was hot to the touch.

 

A little heat, the fishing line, peel the extra adhesive with your fingers, wipe off the glue with a mild reduce, 2+2, or goo gone, and use a cleaner wax on the area to remove the shadow I just did the whole truck last week in less than an hour. For God's sake don't use a heat gun unless your used to it and don't get the emblem too hot or you can end up peeling the paint with it now that will ruin your day quick

 

Today I changed my oil and took a sample of it to send to blackstone labs. Also greased the driveshafts since I haven't done them since last oil change. Took about 4-6 pumps of grease before they purged. I also cleaned my radiators since my truck has been running hot when I am in hot 105+ F weather. I sprayed the engine off while I was cleaning the rads since I was already there. Can you see what part I didn't have on when I cleaned the engine bay?

 

2014 T4R brake swap, SS Lines, new wheel bearings and EXT Kings

 

I was going to do my calipers red, but after seeing the Ray 10s (probably my next mod) with the blue I might have to reconsider..
What paint did you use and where did you get those stickers?

 

Didn't even see the t4r brake swap, any noticeable braking performance?

 

CB Radio antenna cable maybe...

 

Built a new sub box. Blew out my 2nd Kicker 8" in 3 years so I'm upgrading to a 10". Couldn't swallow the $450 for a JL so I got a new "b stock" Sundown for $140. Access cabs aren't easy but this proves it's possible to have a subwoofer that doesn't interfere with any of the 4 seats whatsoever!

Proof of concept in cardboard, original box on the right, beginning to build a stick frame. Changed a few things by ~1/2" to fit the bigger sub, changed from down to side firing:


Stick frame fits great:


Time to cut some MDF:




Make sure its square!


Now we let the wood glue cure & caulk it tomorrow

 

I just used high temp paint for calipers I think, or engine enamel, duplicolor spray paint. Along with the same primer and clear. The stickers I made at work and cleared over them

Thank you

 

Thank you for the reply and inspiration

 

The black plastic radiator cover.

 

That's all?

 

I'm going with the hood prop.

 

these are pacer nighthawks. got off of ebay for like 450

 

http://www.periheliondesign.com/switchguards.htm

https://www.radioshack.com/products/spst-submini-sw-1

@smcgill