I need someone with an Automatic 2.7l 4WD Extended Cab

I'm collecting parts for my PreRunner 4x4 conversion and the only parts I need are the front driveshaft, and the front portion of the rear driveshaft.

Can someone please measure the:

• Front Driveshaft (Front Differential to Transfer Case)
• Front Portion of Rear Driveshaft (Carrier Bearing to Transfer Case)

Does anyone know if the 6 cyl 3.4l front driveshaft will work on the 4 cyl 2.7l?

Thanks a bunch.

 

Front driveshaft: 28.5"
Front half rear driveshaft to center bearing: 24.5"
Crappy cell pics with one hand...sorry.

 

Seriously, thank you. One step closer to having 4WD.

 

Hope it helps and good luck with your conversion.

 

Thanks a ton man. Really appreciate it.

 

Can someone else get this rear driveshaft measurement indicated below (red line)? I have one lined up but don't know it's right size. Must be flange to flange (where the bolts go on each side)

 

Get both measurements. Or did you source a front drive shaft?

 

@nzbrock

 

Got the front driveshaft with ToxicTwin's measurements, but the rear D/S measurement was a little off.

 

Anyone?

 

If you don't get anyone to help with the measurements over night, I'll get them for you in the morning before work.
Just the front portion of the rear correct?

 

Yes thats all he needs

 

Thank you man I really appreciate that.

 

Front portion of rear driveshaft, 28 1/4 flange to flange.

 

That's perfect, thank you man.

 

Some info here

https://www.tacomaworld.com/threads/transmission-swap-write-up-s.384303/

and here

https://www.tacomaworld.com/threads/transfer-case-transfer-cases-in-first-and-2nd-gen-trucks.345652/

 

No worries, sorry I didn't get it right the first time for you.

 

No problem. Thanks again.