What Have You Done To Your 2nd Gen Tacoma Today?

Where did you get the seal and O-Ring? Here in NorCal, all the dealers will not sell me a seal due to they are being prioritized for the Turd Gen axle recall. Called 4 dealers already and same thing...

 

Just get the part number and look it up online. There are plenty of places that will sell you factory parts cheaper than the dealerships.

 

I did, but Amazon, Rock Auto, etc take about a week to get it, and the axle is already leaking bad enough. It's my Daily so....
But I am shocked that we cant get parts from the dealers/ Toyota and that they would do that. They explained that I could get one, but an email would have to be sent to Toyota, then 3 or more weeks later, etc etc...
Thanks for the reply though, I'll guess I'll wait for one!

 

Heat sealed the ditch light connections

 

Received my Redline Tuning Hood QuickLift Struts today. Installing them tomorrow!

 

finally finished up my lift!

 

Purdy!

 

youre purdy.

 

Update on my light install. I drove from Georgia to North Dakota over the last 28 hours. The back up lights were only used briefly a couple times due to tailgaters. The Oh Shit look on their face was very well lite, and priceless. I encountered some light fog and the dullay SSS with amber covers were amazing, once you get the angles set right. I started with them too straight on and they threw a lot of glare on the hood and into the cab. Angling them about 5 degrees off center really cast a lot of light out the driver and passengers side windows into the ditch.

 

Wanna know if your TRD Offroad is pre-wired for those sweet TRD Sport turn signal mirrors? @briscoe53 's truck featured in the outro!

https://youtu.be/68iaGLwQGfs

 

When your mom asks you to pick up a "small" desk for her while your up in the city for work...


And then you get home from a long drive and unloading said desk, to find a pleasant surprise on your front door!

 

Exhaust re-route and skid mod

 

SQUIRREL!!

 

I got to use mine as FU lights the other morning on the way to work (around 5:45AM) and some douche was riding with his light bar on, turned onto the road getting behind me. Hit the lights, his light bar went off

 

You should buy a set of cheap harbor freight tools to keep from scratching your door panels and the metal parts of your door, or you could wrap your screwdriver with some tape to help keep the scratches to a minimum.

 

They are EVERYWHERE.

 

Good tip.