What Have You Done To Your 3rd Gen Today?

Thanks bro! Go with mine bfg ko2 265/75/16 but you will have to remove front mud flaps so it won't rub. I do have a lift fox 2.5 upfront and fox 2.0 in the back.

 

How much lift did the fox suspension give you ?

 

More or less gave me 2 inch up front and 1 in the back. So it leveled the truck.

 

What wheels are those?

 

Swapped out the extended bilsteins, aal and 2 inch blocks for icons and all pro expeditions.

 

Finished up installing the kicker cs speaker and tweeter upgrade Definitely worth the money.

 

Great color choice!

 

*****************
Sent you a PM.

 

Finally tinted the windows. Limo in the rear three windows and one shade lighter for the front two.
I think the front is too darks. I’m so getting pulled over. Might go lighter.
Also wired my Cali Raised LED Ditch lights. These are awesome!!

 

So - curious - did you sound deaden the entire floor. Did you ever get rid of the noise coming from the back? Considering this...

 

Finally put on my retrax cover...

Pretty solid, but I ran it through the car wash and it's water repellency is disappointing. To be fair I haven't installed the drain tubes yet.

 

I Installed the center console organizer and tray. Lol, not a major install but not bad I guess. I like the tray but don't really like the organizer so much. I might have to get the dremel out and whack off one of the end pieces so I can make one larger spot on the end to fit my emergency light, tourniquet and quick clot laid down horizontal in the same spot, cuz hey you never know...

I'm contemplating plasti dipping my badges today and grill also.

 

I had the same cover.
Also:
Definitely install the drain tubes.
Put some silicone on the front 2 ends of the truck crossbar up front to fill in the gap if any.
I ended up putting some silicone where the drain tubes connected to the GatorTrax box too.
Make sure the rear part of the GatorTrax frame is the same height on either side to the truck lip/plastic frame on top of truck. In the directions it says you might need to sit on the GartorTrax frame when tightening down the rear attachment/bolt assembly.
Mine was not level and caused a slight leak that was running down through the center/ middle area of the cover.
Back at the tailgate put some weather stripping and fill in the gaps with silicone between the plastic liner and truck bed. This is where most of the water will come in.
That will pretty much seal it all up.

 

I also put 2 strips of gun grip tape on the center divider of the tray to grip it....it's slick otherwise.

 

Got some plans in the works! Very impressed with the custom buttons from CH4x4 and the overhead switch panel on Shapeways

 

In for pics

 

Finished the lift yesterday afternoon. Wheels and tires are on and it's going in for an alignment in a couple of hours.

 

Did 100% of outter skin and 70% of inner panel with dynamat then dynaliner. Floor and back as much as possible. Still a little noise in rear from back wall vents I believe.

 

Got the Wheels/tires for the hoopty mobile put on. Not a surprising combo

BFG KO2 265/70/17
TRD SEMA 4 Runner Wheels
Black lugs on order...

 

BUAHAAHAHAAA! Scrolling down the page... and I just about spit coffee all over my computer! Great pose. Truck is lookin' proper. Thanks for the laugh.