What have you done to your Tacoma today? 1st Gen Edition

Mine broke because I was trying to reset the hydraulic tension. Was new.

 

Turns out the belts the correct one, good thing the part number is on the belt itself.

 

Just let me know!

 

I would suggest an alignment. Why not.

Also, he shouldnt need a press

 

TENSIONER 13540-62021 $39.22
ILDER TENSIONER 13505-62070 $114.44
T-BELT 13568-YZZ03 $40.93
Does that hoes run to a metal pipe?? if so 17343-62090 $9.89
shows to have it all in stock

 

I misspoke, by press I meant puller, like a tie rod end puller. Mine were a bitch to get off the LCA, I used a Tie rod end puller and Ball joint separator at the same time. and I never got an alignment and it drives fine, Im just speaking from personal experience though.

 

That's what I'm counting on if I can ever finish my sliders.

 

So I confirmed that I do have the correct timing belt, and I got impatient and went to the local stealership for the ilder tension and hydraulic tension, RAPED.

For the vacuum hose it does connect to a metal pipe under the runners. Can you paypal me the quote for the igniter connecter and the hose?

 

What was the outcome of the stripped drain plug?

 

I have those plugs
Edit: looks like gunny took care of you.

 

Sure can, what was your email address again?

 

Just ended up ordering a whole new pan and drain plug from Toyota. Not the cheapest way to do it, but I wanted it done right and didn't want to risk any leaks.

 

Thinking about tryin to do a thing...

 

Do a thing

 

But I gotta cut it....

 

Does anyone know the angle of the auto tranny flange. I'm getting vibes and need to check my angle of my tranny and pinion angle. Any info would be helpful. Thanks.

 

You using a single piece DS? Shouldn't matter much with a two piece, I slammed mine up another .75in and no vibes but I could see that messing with it if it was a solid DS.

 

Let us know how this thing goes and how hard this thing is....I want to do this thing as well. Sometimes things do not go well for me!

 

Yeah Double DS. But I still don't have factory mounting points on the truck. When I installed the 3.4 and 4x4 converstion I never check angles. I went off measurements off another first gen. Now that the new mounts are broken in I want to double check my angles to make sure that isn't causing the vibes.

 

I believe