NJ B.S. Thread

I missed that.

 

Once you do it there is no going back...

It took Anthony and I about 3 hours start to finish wih mine.

 

Not really. You can go back from anything. You can cut out a crossmember and weld a new one in. You can cut a hole in your fender and get a new one. Just depends on how much money you have to go back.

 

Not too long ago, a guy bought a new fender so he could go from the airflow snorkel to the safari snorkel haha

 

Actually got a used OEM replacement and repainted to the truck's color

 

True body work is needed for the a pillar holes it really isn't hard to go back but ya know.

Ive also asked people time and time again if they would do it again if they never did it and they said no

 

Anyone have some headlights they're looking to get rid of? I'm out of spares and need new ones

 

Da fuqq what would make that gap

 

Body lift...

 

You don't need to drill the A-pillar. My "Velcro" is holding up just fine.

 

See? Hardcore!

 

...

 

If you looked at my bracket you would know I needed to. My fender is not aligned properly from probably bumping a tree and I had to use a reamer to ream the holes out

 

Body lift and NOT springing for the extra $50 for the bumper relocation brackets.

 

SMH.

 

I have a passenger side I think. Driver side is good for guts and lens but is destroyed from my fender bender mod. Needs a little bit of a buff

 

4xcrawler does iirc

 

I may soon be doing 2 inch



Of course after building the rear bumper....doh

 

Body lifts aren’t bad if done properly. I’d avoid anything past 2” though - fitting everything up to look proper afterwards is all wonky.
1”was plenty for my needs