What Have You Done To Your 3rd Gen Today?

Sounds good. It rains here 7mo a year so not looking for water tight. Just keep stuff out of direct rain n snow. Little water on bed floor is fine. Thanks

 

Threw these guys in, and got em dirty already. They've been sitting I'm my front room for a month lol.

 

Does the MGM match the console trims?

 

Dipped the grill (left the ring and toyota chrome for some nice contrast to go along with the rear bumpers chrome). I love it!

Also dipped my badges but it was a total pain in the ass especially the V6 one which I got fed up redoing and just debadged it (just the V6) which I think looks a lot better. Maybe I was putting the tape too close to the darn letters as it seemed when it dried and I pulled the tape off some would come off where I wanted it to stay. Anybody have any tips on this?

And finally I cleaned all the black trim and under the hood and interior doors with mguires ultimate shine.

 

The little trickles that make it into the bed just go right under the bed mat (if you've got one)...so there's really no need to silicone the holes if you don't want to.

 

Did the subaru tweeter upgrade today. Also got a sneak peak of my clazzio headrest embroidery!

 

Wheel and tire upgrade for treacherous mall parking lots.

 

Is the tweeter swap plug in ? meaning not cut wires "plug and play" Once the pilar is out and the grill and 2 bolts?
thanks

 

Yep just plug and play, just two bolts and the speaker grilles, I didn’t even remove the pillar. Took about 10 minutes total

 

Tint! 20% on sides and rear. 50% on the windshield with a 10% sun strip. Had this on my 2005 and loved it.

 

Man i love that windshield tint. A/C has to kick ass.

 

The windshield tint is great! Barely noticable outside and inside its the perfect tint.

Night driving it's barely effected, honestly. I live out in the country, no street lights, and it's fine. I have astigmatism so my eyes are really sensitive to light. Gives me headaches. This helps so much during the day and night.

 

I always grab a trash bag, open it all the way up, then cut a hole around the badges then tape it down. Prevents a lot of over spray. I'll leave a gap of about 3 inches or so away from the badges. Peel away from the edge of the badge you're peeling from. Not necessarily straight away from the truck, if that makes sense? Wish I still had pictures. Anyway, the tension from pulling away will pull it apart right where you want.
Then between the enclosed areas, a toothpick works great.
Hope this helps!

 

Moved up to 35"s They fit but at full lock rub a little on the body mount chop, not enough to be annoying. Regear happening in the next few months but I am not noticing much loss in power.

 

i went with leafs and now i have squeaks...if i cant get it dialed in i'm going with a block

 

The stock leaf pack is pretty notorious for squeaking, fyi.

 

yeah...it's driving me nuts...not like its a brand new truck or anything

 

Trust me, I know.

I'm doing the right thing and spending a bucket of money on a new RXT rear end.

I would also recommend the Deaver springs, apparently they're coated in such a way that they don't squeak.

 

I love it when people do awesome things to pretty much my exact truck and put pictures of said things on the internet for me to look at. Hot damn that looks good!

 

Where did you get them,? I want some could you lets us know thanks