90yota's "BROVERLANDER" build/work in progress SOLD

Someone love tapped the hitch the other day. She’s infected.

 

Whose HC are you going with?

 

Likely @Pelfreybilt. They do good business on island with their Group Buys. The front bumper I got from them is sweet. The top of the plating is just big enough to set beer cans on

 

I wish they made a swingout so that way you can get a table on it and have a huge spot for beer cans

 

They do for their standard. Maybe they would for their HC. I also would rather just pack a BBQ set and chairs and whatnot, but that’s me. I can drink anywhere

 

I was looking at Bruteforce for a rear HC. Not sure if he ships OCONUS

 

It’d cost an arm and a leg without a group pallet, and I ain’t about that life haha.

 

I sometimes I wish I would have picked that one up. Mine already has a couple dents and even one small hole.

 

Sick build!! Puts mine to shame!!

 

Your build looks good too! I like your bed setup too.

 

They are making one! I am patiently waiting...

 

How'd you manage that? Someone sponsoring this bad ass build or what?

 

I wish this build was sponsored. Would have a lot more money in my pocket if so. All thus build was bought out right. Few discounts, used skid and a few GB but nothing was sponsored. All hard work paying this build

 

Military Star Card

 

I actually got the deaver expo 2 pack from @HeadStrong Off-Road fingers crossed I don't need shims since I didn't get any lol I do however have the carrier bearing drop just in case but i'm freaking out i'm going to have the vibration issues everyone is talking about...

 

Just sent you a message, but really, don't worry man. I never ran shims, still dont and never had any vibrations. Definitely throw the carrier drop but other than that, you are good to go.

 

you and @erok81 are starting to make me feel better but you guys both had icons and I have the extened kings 2.5 so fingers crossed! i'll be sure to let you guys know how the install goes tomorrow... i'll be doing it solo so I figured the safe route would be one side at a time to prevent the driveshaft from slipping out lol

 

@JTS2014TACO has kings and Deavers, no vibes.. Just the carrier drop.


As for install, either use a ratchet strap around the pinion and over a frame cross member or a small jack stand under the pinion. You'll want both sides of the axle free from the springs so that you can actually move the axle around to get the springs in and out easily. Not much to worry about regarding the driveline falling out.

 

gotcha, I think it'll be fairly smooth... the hardest part is going to be lifting these damn things into place by myself lol they weigh almost 70 pounds a pc!

 

I hear that! I did the install myself as well... Well not the RXT, had broken ribs when that one went down but I did do the Deavers solo