What Have You Done To Your 3rd Gen Today?

Tonneau cover and bed mat.

 

That rubber looks slippery if it got wet. The oem looks more rough, and is made of recycled rubber I think. Looks nice though.

 

gotta link to where we can buy?

 

the wifey got a silhouette this week so i cut and installed some vinyl today. looks real nice...

 

So when you are driving are the tubes on? Just trying to make sure before I order. Like when your lights are on auto are the LED tubes on?

 

Do they melt off with the heated mirrors? Had some circle ones on my truck that I got at Target, and they slid off

 

Lol...never thought of that...

 

Its not. Its grippy as hell. Its brand new, thats why its shiny.

 

Ordered mine from Carid.com
Its thicker than the tacoma factory rubber mat, nylon impregnated. Very grippy. I had one for years same brand in my old toyota 4wd. I hauled engine blocks on it, furniture, firewood, surfboards etc. Never did any damage to it whatsoever.

 

Where are you located? Nice to see more Washington State plates on here - Clay

 

I just installed these. First I used some GoofOff on the area where I was going to stick....then wiped with alcohol....then stuck on the mirror.
Just be careful not to get any GoofOff on the mirror black trim.

4 Pack Blind Spot Mirror, Maleb Square No Blind Spot Mirror for All Universal Vehicles Car Side Convex Rear View Mirror Wide Angle Blind Spot Mirror Fit Stick-on Design

https://www.amazon.com/gp/product/B072HT2WHW/ref=oh_aui_detailpage_o06_s00?ie=UTF8&psc=1

 

I'm near Morton along highway 12

 

Very, very nice. Both of em

 

Newly Installed:
3" Pro comp lift
20" Fuel Hostage lll wheels
Nitro Ridge Grappler tires

Previously installed:
TRD Pro grill
TRD Pro taillights
Black out badges
American flag decals
led light conversions
Weathertech floor mats
Hondo Radio knobs
Tint
Salex Organizer
Door sill protectors
Bed Mat

 

What did the lift cost you? And his is the ride compared to stock.

 

Wheels, tires, lift, $3000 installed. The ride is smooth. I've only had it 2 days. Not enough time to really notice anything except a little rubbing in tight turns.

 

That’s not too bad at all. Esp installed. Did you order it or a shop do it all for you?

 

The shop did it all. Cash deal.

 

Looking for guidance! Wiring up Rigid LED's to a Toyota Push Switch, and not sure what goes to where? From the Rigid relay I have a Red, Black, and Blue wires. On the switch, Green, Red1, Red2, and Black. From the switch, I'm assuming that the Red2 goes to dash lights, and BLK goes to ground. From the Rigid Relay, is it Red to Red1 on the switch and Green to Blue? Any help in not burning up the lights, dash, or entire truck is completely appreciated