Northern Virginia Roll Call

pm me an i can get you squared away

 

I dunno why it keeps putting me in the qoute

 

I'm still planning on rolling out. Meeting at 0930 for a 1000 roll out works for me. It's funny because because I was just looking on Google Maps, and no matter what route it gives me it's basically 2.5-3 hours. When I told it to avoid highways and tolls, it came up with the shortest routes and the drive time was the same.

What caverns are you checking out? I went to the Luray caverns earlier this year, and they're really nice.

 

Right now I just need to get a light bar installed, and tie in a switch for it. Not very knowledgeable when it comes to electrical. always enjoy learning new things, Especially when it comes to working on my truck. (So learning from you guys would be much appreciated) Have some other mods coming in the future but I have to pace myself. The forum is dangerous for the wallet.

 

I appreciate it. I will reach out to you this week.

 

I am interested in the wheels but not the tires. Let me know if they end up getting split. I know the chances are slim, but just puttin it out there...

 

I'm good with basic electrical work, so if you want to learn, swing on by! I'm off a lot, so we could work out a time.

 

I'll keep that in mind!

 

sounds good

 

Ok cool... let’s plan to do that.

@Darkgoatracer sound good?

Those that have wheeled sleepy creek, will I need my sliders installed?

That and the snorkel is the only 2 major things I have left to install now.

 

Did this today....

 

Anyone know of any good places to stop/eat/look along Skyline Drive? Going to make the drive out there next weekend to see some fall colors hopefully

 

Nice. Is it just me or is that a lot of threads to be cranked down? Heavier springs might be a good idea with your bumper/winch/skid, so you can run less preload for the same lift.

 

It's probably close to the max. I think up to 2" of thread exposed is okay before coil bind is an issue.

That detail is in the paperwork that comes with 'em.

 

thanks for the info man!

I'm going to probably keep my eye open for some Icon 700lb springs for the future

 

Im good to go. Would be interested to hear from people that have been there before.

 

Sliders are always beneficial, but I wouldn't say NEEDED. Just be a little more careful and you should be fine.

 

yea, I put one slider on jack stands to see how everything is going to fit, and I dont see ANY holes that already line up on the frame..... @TacoCat can you provide any insight?

 

Jb weld....