AZ BS Thread 4²0

I'd just stick with a cut off wheel. It won't be too bad. Not like you have a ton of material to cut through I'm assuming. Just buy a couple fresh blades and go to town.

 

Ifs it's 18ga you may be able to use some electric snips. Can be had at hf for pretty cheep and is decent. But I'd only mess with that if you are cutting a lot

 

and I had a few grand in my pocket already.... so I actually got out of there cheap!!!

For many it is a serious problem... I need help!

Not this weekend, but hoping next weekend. Might even give it a try in the driveway!

 

WISS snips can be bought at most hardware stores. If its thin enough, you can cut easily, but there are left, straight, and right cutters. Not too bad if trying to cut finer edges for fitment after getting the size close with a wheel, nibbler, or reciprocating saw of sorts

 

worm saw works well too for straight cuts

 

I'd go cut off wheel (i.e. Death wheel) forsure

 

I lost so much Horsepower today! Scrapped off all my stickers from companies. Hopefully the sleek new RTT will balance out the loss.

 

I had started putting some stickers on my canopy but then figured why draw more; perhaps unwanted; attention to the truck so now every sticker I get goes on my tool chest instead.

 

I buy the cheap magnetic sheets, put all stickers on that, cut them out and then put them on my tool boxes and garage fridge.

I lost a lot of really good stickers, impossible to replace, when my last beer fridge died.

I vowed, never again!

 

This is really smart. I like it

 

Everything I have bought at IMS has it written pretty small in one of the corners, or your receipt will have it. Or the edge is pink? I would guess 18-20 ga

 

But why??

https://www.tacomaworld.com/threads...-3rd-gen-today.399305/page-3387#post-16218990

 

Typical 3rd gender



Just kidding buddy, I do really like your truck.

 

ha ha you definitely aren't wrong... And thank you.. But I draw the line at color matching every goddamn piece of trip and bolt...

 

Cause he likes it?

 

I'll check the corners of the metal. I opted no on the receipt.

 

I like the color matching he did for the most part. Some parts o wouldn't of done.

 

even through I appreciate his Zest for wanting to make his truck his own, I personally don't find that much orange a-Peel-ing.






I'll see myself out...

 

Well I'm now on 4runners.com how many you on there? I saw @4Running Daily is. @MaverickTRD isnt

 

I never use that place ever haha. Not enough actives