What Have You Done To Your 2nd Gen Tacoma Today?

Did the differential breather mod this morning. Ran the breather to the top of the inside driver side tail light. I figure if water reaches the upper part of the tail light, Ill have bigger problems than dirty differential oil.

 

Installed WeatherTech in -channel window deflectors . I like having my window cracked even in the winter so these work perfectly.

 

Just bought a chase bar from Baja Designs. Fabrication gears are turning...

 

Wow that is definitely a head turner! Did you paint it yourself or have it professionally done? If professionally, what'd it cost ya?

 

I'm not a fan of the matte paint trend . Even though I said that , that looks incredible ! Well done , great job and whatever other compliment that's out there .

 

Can you confirm that this removes the seat belt chime???

 

does yours not get turned off with the key in ignition/holding the odo button combo trick? it does on my 2011

 

Thanks for the order!

 

I have not found this combination trick yet. I found an older thread that had a combination for the chimer but it failed to work on my 2011. Do you have a link?

 

Or you failed to execute it correctly.

 

https://www.tacomaworld.com/threads/disable-seatbelt-warning-chime.38842/

that works for me every time.

I think the first time I tried it, it took me a couple of tries to get it right. (I probably couldn't count that high)

 

Thanks! This is not the one I had previously tried. Can't wait!

 

This is also a possibility.

 

To turn the chime off do this:

1) Turn the Car 'ON', but do not start the engine (Leave your foot off the brake). Cycle your trip reset knob until it reads ODO. Turn the ignition back off. Wait a couple of seconds.
2) Make sure seat belt is not fastened
3) Turn the ignition back on, do not start the car (Leave you foot off the break) As soon as you see everything light up, press and hold the trip reset knob and do a long 12 second count.
4) Keep your finger on the trip reset knob. Fasten your seat belt, as soon as you fasten your seat belt, you should see the ODO display go from XXXX miles to "b-on". At that time take your finger off the trip reset knob and press it again. It should cycle to "b-off". You should be all set and turn the ignition off and unfasten your seat belt.

 

good luck and enjoy! I know they changed it up in the later 2nd gens (I think 2012 or so) that could have been the one you saw

 

If you have a link to that one, I'd appreciate it. The older second gen chime off doesn't work on my '15.

 

I don't have the link sadly. its on here somewhere though

 

https://www.tacomaworld.com/threads/2015-seatbelt-chime.479469/

Looks like you need the dealer to do it (or someone in your area with techstream)

 

Set of these came in yesterday for me. About to go install them

 

Got a new cabin air filter today... maybe a little over due