What have you done to your Tacoma today? 1st Gen Edition

Once I wire everything up no prob - I'm going to be using:

https://www.paranoidfabrications.co...st-gen-tacoma-din-switch-plate-6-switch-holes

for the switches and making my own wiring harnesses. There's a lot of basic info in my led pod install here including how to save money by making a wiring harness instead of buying a premade one:

https://www.tacomaworld.com/threads/anthony-y-el-burrito-blanco.372728/page-4#post-13547645

 

Should be able too pretty easily. Just two bolts. Shove the current stock one out of the way and bolt on the tundra one then slap on a wheel. 2nd gen ones will clear for sure.

 

Alright, who let their dog drive....

 

DD = Dog & Dog?

 

Headlights are in!

 

Got this today
https://www.youtube.com/watch?v=azuKtXF6f14

 

Threw in some big washers between my transmission skid, it was rubbing my sway bar. I'll think of a better fix later. I'll probably just drill out the holes on the ifs skid so the it sits lower on that end. But it's 3/16 steel. I don't have anything strong enough to drill it out .

 

your buying the wrong drill bits

 

Why not remove the sway bar?

 

this looks interesting, I wanna start beefing up my frame too, didnt know these existed.

 

They make sections for the whole frame I believe

 

yea looking through the site now, surprised i haven't heard of this earlier. Now I'm considering getting the center frame section before welding on my sliders...

 

Must.. not...order...battery hold down! You guys are killing me. Dang, that looks good.

 

Order it

You need it

 

It's my DD as well. And body roll annoys the shit outta me

 

What should I be using?

 

do you disconnect the sway bar when wheeling?

 

dont think ive used a bit that couldn't last through 3/16" steel? even the chinesium ones

 

Lol well I guess I havent tried. I have a good set of bits, just assumed my 18v drill wouldn't be strong enough. I'll give it a shot this week. Already dark outside