Remote start from accessory wire?

So I have an Audiovoxx aa-925 keyless entry system, and it has two accessory wires that can be used via the remote. How would I go about setting up a remote start only using an accessory wire? If anyone has input that would be great.

 

That's a good question... bump

 

You don't. There is more to a remote start than can be provided by 1 16 ga wire.

 

Yes the alarm has to have to capabilities to power an ignition wire, verify that the engine is running, and give you the capabilities to disable the remote start once the key is in.

 

Well of course, anyone knows that. I'm looking for someone with the knowledge to setup a system using relays and such to make it work using the one wire as a signal wire to start the process.

 

Read the manual and that crap doesn't even tell you how to do it. Only that for option 3 you have to "hold the button for as long as you need it". Kinda crazy.

 

Yes, the manual doesn't state how to wire a remote start. That's why I'm asking around.

 

You probably need and additional device that was an option, and this thing is outdated too.

 

That's what I was thinking, but couldn't find a device. As far as outdated, yeah, I got it for $15 haha. But I works really good as far as keyless entry goes.

 

BAMMM

Audiovox AS9076C Car Prestige Add-On Remote Start System

https://www.amazon.com/Audiovox-AS9076C-Prestige-Remote-System/dp/B0045TOEPE

 

Well what I'm hoping is to not have to rewire everything. I'll have to look into that more I guess and see what installation entails. Thanks though. I'll let you know if I figure anything out.

 

wth are you talking about, you're running additional wires from this device to your car to start it, all you need to do is run wires from your current keyless entry(option 3??remember that in the manual??) to this device to trigger the remote start function. Your current keyless doesn't even have any wires ran to specific ignition or starter functions dude.

 

It does actually have both ignition wires connected to the module for an ignition cut-off option for the Audiovoxx that I have, dude

 

So look, thanks for the link, but if the rest of what your saying is going to be douchey comments, bug off.

 

Please show me these ignition wires. What color are that go to the ignition?

 

The yellow 12v positive ignition wire. And then the black ignition wire, can't remember off the top of my head if it's the black or, black/white wire.

 

Ok. I'm leaving this here for you. GL. The relays you have to get must have the diode in them or else you'll have to remove them.

 

Thanks

 

I edit post, please check it again.