What Have You Done To Your 2nd Gen Tacoma Today?

Do you notice if dirt/mud & crap cleans up easier with FF coating?

 

This is my 3rd year doing it. Dirt and snow/salt doesn’t stick to anything you spray, that’s what makes this stuff great. My underside still looks brand new after 3 Chicago winters...

 

I planed on doing the fluid film spray down today but it is raining. I will get it done before Thanksgiving.

 

Installed my modified Corolla mirror switch, replaced blue oem LEDs with white to match the rest of the dash.

 

I noticed this morning that all off my LED's are out on those switches except for A-TRAC, Auto LSD, and RSCA OFF. Where did you get your LED's?

 

painted my exhaust & muffler!

 

Just try and do it before your first snow of the season.

 

We do not get snow in Atlanta we get ICE, But yea I understand it needs to get done soon.

 

Changed the oil & filter, and the cabin air filter.

Also did wiring for a temporary Grote rotating light a few days ago.

 

eBay for surface mount (smd) as this and the attached require tiny LEDs to be removed and resoldered... I am working on steering wheel controls next and will try to take pics in progress

 

Installed wet okeles that I bought from a fellow TW member....

 

All switches left of steering wheel take NEOwedge t3’s but make sure you measure the stock bulb height because some places will sell you t3s that are too long/bulb lens too long and won’t allow switch to articulate. Most of the SMD types are short enough though.

Smaller type Toyota switches under HVAC need full dissasemble and likely soldering a new bulb in to change color.

 

Got a case of filters from the dealership for about 55$ changed my oil and rotated my tires

 

Thanks

 

Well the camper shell is officially finished! Finished the bed liner yesterday.

 

Got these delivered today for this. 200 with the center cap on eBay. Now day dreaming until they are on. Anyone know where to get a set of quality black lugs?

 

One per switch?
Does the face of the switch pull off or do you have to access it from the back of the switch?

 

Well today I made a cover for my 20” front light bar. But I have been very busy this week with the truck. Did my 40K oil change and installed the Fumoto (

$37 F103N with LC-10 lever clip FN-Series Engine Oil Drain Valve, 1 Pack

F103N) oil pan valve. Finally gave the front end a lift by installing the Bilstein 5100 adjustable coil overs set at the 2.5 setting. And lastly, installed the dual Hella Sharp Tone horns. Over all a very productive and satisfying feel good week.

 

One per switch if I recall correctly, except the inverter switch if you have that.

Not sure about the smaller switches. I left my interior color scheme green so left them alone.

Have to pop switches out and bulbs are on side, twist them with screwdriver to then pull out.

Bottom row can be accessed by pulling fuse panel cover off and popping switches out. Top 3 much easier if you just drop the lower dash which takes maybe 5-8mins first time. Super easy. Just take your time. Some try and access the top row without doing that but to me you mineswell make it easier on yourself.

 

I have the Inverter Switch, but only the backlighting is inop.

They sell them by the 10 pack on Amazon.