Great White Taco build

if its your lower ball joints....might as well just go tc or dirtking lca lol

 

get some spindle guessets too @EatSleepTacos can weld them on for you

 

LOL his truck would fall apart after that.

On a related note, I'm still trying to decide on my first project. I'm thinking of making a Jerry can holder that will bolt into my bed platform.

 

I’d start with the wheel bearing. Then go from there Before you start replacing your entire front end. You can at least see that that’s shot.

Up down movement on the wheel is wheel bearing which you have In the video. Side to side is tough. You could be moving the whole rack and steering wheel/other wheel. Or if not then it could be bad tie rod, rack bushings, ball joint. Bit trickier.

 

If I remember right, weren't your wheeling bearings shot quite a while ago back when I was replacing mine? Doesn't hurt getting extra tie rods as sometimes those die on the trail, but maybe swap out the tie rods now and keep your old ones as back up?

 

This is the first time they have been shot. I might have been thinking about getting them earlier.

Im going to replace them, and then move on from there. Youre right, not a bad thought to get the replacements though.

 

SAS or unsub ​

 

screw replacing lowers and staying stock travel. just go lt at that point

 

Start with wheel bearing then move to most likely ball joint

Matt

 

New parts are fun. If they’re easy..

@SlashMTB10 got the hookup on the other parts

 

spindle doesnt have to come off to do a bearing

 

what happened to your old tcase skid? you bend it?

 

nope. It was meant for a non rerouted exhaust. When I put on the URD Y pipe, it is rerouted. So I sold the old skid, and got the higher clearanced new one

 

ah, thats right. forgot you went with a new exhaust setup.

 

True

 

Did you have to space your bumps with the b110s?

 

I think they already came spaced. I bought them used. They look taller than other people’s

 

Got them from @nj636

 

Got pics?

 

I can get when I go to lunch in a couple hours. Stuck in work right now.. Ill look on my phone too