Cup holder bezel

Scratched the hell out of my cup holder bezel. Anybody make some aftermarket carbon fiber versions of this for a manual?
thanks dudes

 

bump^ for anybody with anything to say about anything

 

Used a product called Plasti Dip spray for a similar occurance...spray on plastic in a few different colours. Practise a bit before hand just to get spray/thickness down pat. In Canada, available at Home Hardware, not sure about US.

 

i made a couple.. pretty difficult and my time doesn't allow me to produce alot
http://i563.photobucket.com/albums/ss80/sk8terx010_album/DSCF6880.jpg

 

NICE, got a pic of it installed in the truck?
Can you fab one up for me?

 

ya i can probably fab you up one in the middle of may after school geys out, i'll keep you posted around that time

here's a pic installed
http://i130.photobucket.com/albums/p262/sk8terx010/DSCF6949.jpg
http://i130.photobucket.com/albums/p262/sk8terx010/DSCF6885.jpg

 

Diggin it.

You wouldn't happen to be located in southern california?

Hope it works out after the semester

 

naw i live in vegas, not too far from there though

 

I wrapped mine in matte black vinyl.

 

dang i like it!!

 

Close enough. Shipping should be cheap since its small and light

smart

 

BTW, how much did it cost for that piece of carbonfiber? Cause I gotta factor in shipping and your time

 

the piece of carbon or how much do i charge? carbon fiber usually runs about $70 a yard, shipping should be whatever the flat rate is

 

Basically what would you charge for the carbon bezel

 

I usually charge $100 plus shipping, i have only made 4 of these so far because the process is pretty extensive. Like i said carbon, epoxy and other supplies aren't very cheap so i only profit about $22 each time i make one.