What Have You Done To Your 2nd Gen Tacoma Today?

Nope....after you spray it......just leave it. Nothing sticks to it so no need to wash

 

$12.00 for three knobs?

 

Where to order?

 

Changed transfer case, front diff and rear diff fluids. Also installed my new rack!

 

Got 'em in my Pelfreybilt bumper. You made the right choice.

 

Yep.

 

That's what I want to do get a front bumper, preferably aluminum. I saw your truck on here it looks nice, the 05-11 bumpers looks real good, nice and clean around the head light trim. For now those nice lamps will go in the plastic bumper.

 

Mine is aluminum. I went with Aluminum bumper and skids. Saved about 125 lbs. My lift didn't drop much....About 1/4". Truck handles better without the extra weight. Also used a synthetic winch cable. That saved 35 or so lbs....

 

Finally got my hands on this light bar. I might be able to get a couple more anyone interested? $210+shipping

 

going to finish installing this today Bilstein Adjustable 3″ lift kit with 5100 shocks for

$70 2005-2015 Toyota Tacoma With 4L Right Petrol intake air snorkel kit high performance system compatible kit Replacement black Rotational Molding (2005-2015)

2005-2015 Toyota Tacoma. Then try it out on my way to town. I couldnt use the spacers though , my upper control arm wont go down far enough to bolt the ball joint back on, next thing to buy is uppers!

 

Installed Pelfreybilt Bolt-On sliders this weekend...


Ended up needing this once too for my finger!

 

I've been eyeing these how do you like them? They are completely bolt on no drilling? Hope your finger is ok!

 

Went to put on my king coils and no directions in the box. Anyone have a link for the installation..

 

So far I love them. There's no drilling, but apparently I jacked up the carrier bearing crossmember on mine so I will have to drill out the old bung and install the screw with the supplied nut.

Finger's fine, thanks! Needed to bandage it up to keep from bleeding all over stuff!

 

Thanks man!

 

I believe it's about 250 lbs!

Edit: Sorry I calculated wrong, It's probably closer to 120-150 lbs

 

Changed spark plugs today at about 90400 miles, made sure the gaps were .043" according to the manual. I'm assuming they were originals since the drivers side had NGK in it and the passenger side had denso in it.
Does it look like they have normal wear on them? They all look pretty much the same, none of them had a smell of oil on them.
Is there something I should look for next time I change them? I put these in a bagto compare to the next time I do it

 

I haven’t done mine yet since owning the truck but it’s looks like they did a good job for nearly 100k

 

Looks like I’ll be ordering up new wheel bearings/ hub assembly’s very soon I’ve got some play in the wheel, was hearing a slight knock sound driving thru a parking lot last night going slow I could feel and hear a knock in the steering

 

Hangerzz