Colorado B.S. Thread

Why you gotta spoil our fun?

I know Ray would've posted pictures of his injury and we all could've had a good laugh

 

I didn't take a pic of the CV, but yeah I suspect the reason for the original replacement may have been water intrusion so maybe they pulled the seal and who knows why it didn't go back in. This is the same dealer that stripped my oil pan bolt and didn't tell, so there's that

 

No way! Makes a good 90* on the table. If you get hurt with my table you should be more careful. If I get hurt then whatever I’ve been in worse pain before. Plus Eric expects better photos of said injury.

 

Lol at that sweater

 

At least we still have hockey.....

 

Hell yeah. They just kicked ass tonight.

 

At least I am a lightning fan and they kicked avalanches ass the other night!

Looking forward to next weeks game when they play each other again.

 

Someone say hockey?

 

I was at CC vs DU tonight - Double OT - epic battle for the Gold Pan - Pio’s prevailed - on a sick spin around wrister - awesome series ——. F’ing love Hockey.

Now - “sipping” whoooooskey

 

One of the mistakes I did with my table. Since the table top frame was notched at 45* angles and bent together. I didn’t clamp down the ends to make sure it was flat before welding. Every thing was square but that little sag will effect the table top. Now I’m going to run a few beads to fill it in and grind smooth. This will make sure the table top is flat.

 

Why not flip table on to flat floor, heat area and slowly smack it flat?

 

Because adding more heat will distort the table even more with a rose bud or torch. Plus it’s easier to add a shim to the top and check for flat then to heat, smack and hope the bend will hold after it cools.

 

Shit how thick is that metal then?

 

It’s only 1/8”.

 

Oh yea if it’s that thin your route is easier

 

Not to bad now. Luckily this is the back of the table.

 

I’m an OCD asshole when it comes to stuff like this, and I could live with that. Nice job dude!

 

FTFY