Basik Built taco

The people demand more videos

 

I know!! I only have like two small clips! And I’m off to work for a couple weeks now so this will have to tie you content whores over for now!

 

well hopefully I can find some time to fix my truck this week and weekend so I can drive it hard again and tie me over.

 

Mmm pie cuts.
Nice work! Looks good!

 

Thanks dude!! Those pie cuts were a hands on lesson from my roomate!(he builds high performance exotic exhaust systems) came out pretty decent I think.... takes some practice and trade secrets that’s for sure

 

What u break!? Probably be fine lol dude I have to relearn how to drive now cause this thing can just absolutely just mow over shit that I had to slow down for before it’s a trip

 

Nice! Haven't dabbled in them yet myself, would like to someday. I always see those exotics with custom stainless (or titanium) pie cut and TIG'ed exhausts and drool over it all. Looks to be one of those things that you have to be 'in the know' to do and do well.

 

Snapped a front axle rock crawling. Had to have been the perfect storm of circumstances cuz I certainly don't think I was pushing it too hard and neither did my buddy that used to run a 4Runner on 38's. Already have the broken one apart and the new shaft showed up today, so just need to get some clamps and grease and it should be back together.

 

I have my old 3.5 over kit for sale very soon....with shocks and axles

 

Well if u ever get a project where u want to do it hit me up and I’ll share a lil nowedge with ya!

 

How much for the axles? I may be interested In those as some spares for the future.

 

Are you talking about something like this?



Exhaust on a CR500



LED exhaust on LRD aluminum framed 250R

 

Sure but there’s a bit of science behind a correct built two stroke exhaust like the bottom picture....incorrect

 

but how???

 

There’s a bunch of how to’s on here, I just jumped a wire that goes Into the blue module thing behind the radio.....

Kind of a mute point since I have completely different axles and spindles on my truck

 

Shuteye peak cruise

 

never noticed the write-ups. I'll look it up. I have the pressurized pipe method for now to keep the tpms light off.

 

Details on axle? Trying to figure out if I want to go full float or semi float. All ruffstuff full float products? Do stock Toyota wheels fit over the hub? (6x5.5" with stock center bore im assuming?) Thanks and been following along for a while just getting ready to pull the trigger on a rear housing. Already picked up my third member.

 

Ruffstuff housing with solidaxle industries snouts and hubs... full floater 35 spline. The wheels I think stockers will work. Full floaters are always better than semi float. Some guys need to keep their abs sensors to get the trans to shift if it’s an auto and 2wd. I have a manual and run a speed sensor that’s gear driven off the transfer case so my speedo still works

 

Cool build man, working my way through it. Love these latches on the table vs a wingnut that most people use. Do you have a name for these, or maybe a link?