Dyno'ed my Taco

The local car board I'm on had a dyno day, so I put my taco on the rollers. It did better than I was expecting. I was thinking it would put down around 100-110 given that I'm at 5500 ft elevation. However, I put down 132.93 HP and 154.56 ft-lb. I'm running an AFE drop-in and secondary filter delete. These trucks run lean as hell though. It was at ~15:1 from 2k-5k. I'll post up the dyno sheet as soon as I can get it scanned.

 

Thats not too bad. Can't wait to see the Dyno sheet.

 

What kinda numbers you get off of your truck Chris?

 

Thanks guys. I took a few pictures while I was there. If you want to check them out they're at http://s16.photobucket.com/albums/b40/buyobuyo/dyno_drag_9-06-2008/.

 

How much would they charge you to make a pull, say after you make some mods to your truck? I'll have to make some calls i'd like to make a pull before I remove my second set of cats and install a different muffler.

 

The place I went to charges $80 for 3 pulls. This was a group event so we got 2 pulls for $40. Dyno charges vary quite a bit though.

 

Wow that super charger did less than I would have expected.

 

Yeah looking at it that way is impressive. How much did the s/c cost? I am still adjusting to making adequate power with V6 engines and forigen vehicles. I'm used to Big block chevys

 

Thats what I have been noticing about our trucks, their already tuned. Nice but leaves little for us to tinker with in that department, not that there isn't plenty of other things for us to do. $1500 wasn't bad, I was expecting closer to 3.

 

here's the scan of my dyno sheet. Sorry it took so long.