Colorado B.S. Thread

Well my family fly’s in Friday/Saturday and I only have 2/3 a 12 pack........ so no

 

Hit those last minute Liquor store sales

 

My Molly’s liquor store rewards account does prosper this time of year

 

Figures the Air Force would give out Time Out Cards...

 

Took the tundra in for alignment, naturally both sides are frozen.

 

Cause its cold outside

 

If only it were that simple.
Fortunately it's not too far out of spec. But I see new lca's in my future. toyota and their 20 year old design....

 

Does Tundra use the same cam bolts? I have one stuck and was going to replace all of them at once (plus Driving Knuckles/ Spindles, CV's, etc)

 

Sure did! My family agreed to have a late Christmas since I won't be home in time. I offered to just mail my gifts home

 

Yota Jim sells complete Cam bolt sets for 1st gens for $10 a pop. He had a whole shed full of them last time I was there.

I'd go with that plus Whitelines over replacing the whole LCA.

 

after driving it home, it drives fine. Sooo...fuck it.

 

Anyone know how to get these out? Want to replace with 1/2” grade 8

 

Is that spray foam?

 

Yeah removed those parts for the new bumper and filled the cavity with it. When it dries I’ll cut it flush and paint

 

Say hello to rust, that is by far the worst thing you can do, spray foam inherently promotes moisture. Should have left it open and let it breath

 

I

That’s what I get for believing the interwebs saw the tacomaholic video and it made sense but didn’t think about moisture

 

These bolts are pressed in. Good luck attempting to remove them. No body does that I have seen and I have never seen an issue where they are the weak point. You are more likely to bend or tear those frame horns before those bolts break.

And sorry but x2 on the sprayfoam as Marty has stated.

 

Kinda late to this party, but about the insurance thing a few of you were talking about not too long ago.... Where are you finding these Agreed Value policies, I have called just about every insurance company in town and nobody can do it. Thanks.

 

Big NOPE lol

 

Well thanks for the info, was going to plate that section in 1/4” and figured the bolts would be a good idea. Saves 26.00 in hardware.