What Have You Done To Your 3rd Gen Today?

Yeah my Limited came with them also. It too is from southeast Toyota. I like them. Especially since they’re DRL and fogs all of which are LED. They look pretty nice.

 

It’s definitely a neat look. Unfortunately, I wish the headlights were also LED.

 

Like the some of the others have said, it's a Southeast Toyota option. My wife's 4Runner has them and I really like them. They are surprisingly bright and the DRL feature looks pretty cool as well. I've only seen them on one or two Tacomas, so if you have any other pics, feel free to share. I was going to get them installed in my truck, but the dealer wanted like $700 to do the install. Found them online for less than $300, so may install them myself or just go with the Morimoto led fogs.

 

Been a good week for the Tacoma.
Just so everyone is aware Santa drives a tacoma, I know this because I bought a OEM tri fold tonneau cover from him. I don’t mean local mall fat guy with a fake beard.... legit.... fucking..... Santa Clause.....
Also just got my SCS F5s from UPS. Won’t go on till spring though along with whatever new suspension I get as winter here in Da U.P. Of Michigan is pretty corrosive.
That being said what TPMS sensors do I use in these rims? I’ll be keeping the original ones in the stock OR rims as they’ll be my winter set.

 

went to Demello Offroad and installed the front bumper and smittybiltwinch last week

 

Oooooooooooooooh, those look like the 3.5bs!

 

Ya I am stuck, I hate wiring ext so installing myself would be a bad idea, but paying a dealer 700 is just madness...

 

I don’t even know what that means but it sounds wonderful

 

LOL!!! 3.5 backspace

The deep lip gives it away

 

Got my lift, wheels and tires put on yesterday. Could not be happier

 

Well they’re offset -25mm. I think you’re right though

 

​

Going to look so nice!

 

Man I miss my 3rd Gen. You fellas have some sweet looking rides.

 

Followed your advice and got the JackCover...much nicer than the OEM HiLift cover that gets poor longevity reviews. You can see how this provides less water intrusion but also has a drain vent, and still covers my fabricated lock, while looking beautiful too! Thanks for the lead...

 

I'll be interested in how you figure it out. I was messing around with my shark fin and was having a hard time trying to reseal it properly so I'm hesitant about drilling into the roof.

 

I was about to go under the shark fin. Design a 1/2" spacer that sandwiches between the roof and the antenna. With a nice hole in the side for wire entry. But I have too many wires, so I am drilling a hole in the roof. Eeeeeek no tuning back.

@JerryTaco ya I have seen their milspec connectors.. Really slick.
I am however going this route, with a waterproof pass through cable gland made by bluesea.

It will be right behind the front wind screen so plenty hidden. the cable exiting the roof will have all Baja connectors soldered on the ends so it will plug into each light accordingly.

 

Here’s a couple I have on my phone at the moment.

They can be. Not that hard to fix, just takes a little bit of cash and about an hour. Just don’t get cheap lights.

 

That plate mount is priceless.

 

Pretty slick!

 

BAHAHAHAAHA "Officer....I DO have a plate on the front"