Relay/fuse panel for 3rd gen tacomas with crawl control.

Looking for a panel to hold some relays or fuses? here you go.
$25 plus shipping and tax if you are in cali.
https://www.paranoidfabrications.co...oma/products/3nd-gen-tacoma-fuse-relay-holder
what it looks like.



where it goes.

 

So is it thin enough to drill through it ourselves where we want to bolt the stuff or run wires through?

 

yep, its made from 08 alu. easy to work with. also if you know where you want holes i can drill them for you too.

 

You think this is strong enough to hold a single compressor ARB which is about 8lbs?

 

A few things to note about this panel;

1) It was designed to sit as LOW as possible. Gaining clearance for a variety of mounting options. @SJaYx2P there *should* be enough room for a single pump ARB
2) It sits ~1/2" above the OEM fog light relay box(smaller black box next to the large fuse box). So if flush mouthing new circuit breakers/relay/fuses etc keep that in mind for clearance. P.S-the fog relay box can be un-clipped and relocated if desired.
3) This bolts in 3 locations for maximum stability. 2 M8's on the inside fender(pre threaded) and 1 M6 to the brake booster(there is a pre threaded nut) at least on the TRD O.R models.. check yours.

Source: I designed it.

OP is great to work with, and the quality is top notch.

Here is a finished pic of mine

 

Pick up option in SD?

 

sure, i am in the mira mesa area.

 

I'd like to know the answer to this as well since I'm not enamored with my current ghetto bracket.

 

I am not sure really, i could try making one out of thicker material too, their small pump should work, let me see if i can get some measurements of one and see how it fits.

 

Thanks, I appreciate it. I will assume the first poster was talking about the

$350 CKMA12 On-Board Air Compressor High Performance 12 Volt for Air Locker Differentials and Tire Inflation

CKMA12, which is what I have. Per Amazon, the dimentions are 9x9x5, which I think might be the box it's in. I'm really hoping your bracket will work, I have the page open ready to hit buy

 

I actually found some specs on their site:

Weight with all accessories and the box: 9.9 lbs
Weight of compressor alone: 7.7 lbs
Height: 5.7 in
Length: 7.5 in
Width: 3.9 in

 

I will be installing the

$350 CKMA12 On-Board Air Compressor High Performance 12 Volt for Air Locker Differentials and Tire Inflation

CKMA12. I won't get the bracket till the 29th so after install I'll report back.

 

Since you're planning on doing the same, I may just go ahead and order the bracket since I'd like to get it done during that same week.

 

I just took a quick measurement off my CAD file. Looks like it should work if oriented front to back not side ways. Hangs off the back edge an inch or so.

 

Thanks, I went ahead and ordered it, I'll make sure to post some pictures of it once I get it done.

 

Just ordered mine. Thanks. I have a pilfreybilt mount but need a blank. Hopefully it comes within the next week

 

it will be in the mail this morning

 

Ill take one with the triangles drilled in side like mesojdm’s. How would i order since its custom?

 

what is the bolt size/ thread pitch for mounting that on the truck?

 

I listed it above. Read post