What Have You Done To Your 3rd Gen Today?

New FOB case from AJT Design. Pick your color to match your Taco

 

I've been waiting for this.

 

Finally put on 17" sema wheels and 265/70/r17 wildpeak at3w's. Stock suspension.

 

Nice man, Just ordered the same wheels a few days ago, can't wait to get them in. Was looking at the same tire too, BFG KO's

 

Yep!

 

Red is king!
I do have some carbon fiber on my ac/c vents and some trim.
My dash is like yours.
I’ll post some images later.

 

I did some research. I think they are both great tires. The KOs seemed to feel smoother on pavement, but I like the aggressive tread on the RGs, and most of my off roading is on sharp rock trails so like the better side wall protection, I am happy with both brands.

 

Are those skids bolt-on?

 

Added the ARB Front Recovery Point to my ARB Summit Bull Bar.

 

Yes 100% bolt on with no modifications. Just make sure you position the bolts in the right areas and line up the plate. There’s 3 holes with 3 different bolt lengths. Shortest should go closest to the wheel to avoid hitting the CV boot and should be tightened last.

 

Put in my new (to me) entune premium radio. I have a few questions and issues which I specified in the main 3rd gen section. If anyone can answer my ? I would appreciate any ideas.

 

Here are my Clazzios..... the back seat bottoms came later since they originally sent me ones without red stitching.

 

I installed a set os Hella horns and did some wireing clean upk

 

So I did this yesterday....
But i have some question if anyone can assist.

The front coils i had no clue couldn't be adjusted while on the truck due to the resonator.
But is there any special spanner to do this while on the truck?

Does anyone have some experience with making these raise to the 3" potential I.E how many threads do you have showing above the coil?

Right now its drooped in the front because of this and i would love to make it even.

Also need an alignment pulling to the right pretty bad.
Now the ride with 12 clicks to firm is damn near perfect IMO.

Thank you for your input.
Next-Alignment w/ mount and balance Methods, 285/70/17 KO2s

 

Where did you put the locker and traction control switches?

 

Many have been able to do it on the truck. Have to get weight off wheel and King spanner wrench I believe. As for height, I have 10 threads on passenger and 12 on drivers side for 2.5" lift so about 4 more would be close to 3".

 

My truck came new with a 2.5/2 spacer lift From the dealer which I changed out to kings so for now rear still has 2" block with factory leafs.

 

Are those just TRD Pro headrests?

Love the seat covers. Very nice.

 

Added a rear Access Cab Husky floor liner and front Door latch Covers.

Before:


After:

 

Where did you find the latch covers