Norcal Spotted and BS Thread

I'm sure there's been plenty of rubbing on his part today.

 

Test fit complete. Just need to notch the passenger side bolt holes, finish sanding and painting and it's good to go!

 

Ahhhhhh shit!

 

I think I still have the fair lead that came with my winch if you want it. It’s nothing special but it’s something to fill the holes.

 

Lots. Plastic, metal, and skin

 

I don't know if I want to pose that hard yet, but I might. Winch is next on my list.

 

Anyone looking for a tire shop needs to go to AVN Motorsports in Alameda

They called to see what torque spec I would like my lugs at

 

Saw a white 3rd gen this afternoon in Larkspur going past San Quentin state prison. Black plates and a Tepui RTT.

Also had his LED light bar and ditch lights on...

Nice truck whoever it was.

 

Haha no offense!






























That's funny though!

 

Pleasure working with you. Don't tell anyone we used solder and heat-shrink in the harness extension. Your fate is sealed.

 

Second this

 

@RelentlessFab

 

Looks ok, normal on the floor jack thing.

 

Thanks, it was the end of the spring sticking out a little past the bushing that bugged me. I’m getting it aligned now so it should be all good. Ride already feels so much better!

 

Do you ever retorque your bolts after service just to make sure they are at spec? My alignment isn’t even over yet and i’m Already thinking about it.

 

I did that same junior guards at the main beach. Years later i find out my wife is in the “class” picture standing 2 kids away from me.

 

Ok DAMNIT. I have a problem with my 3rz. I just drove over humbug summit to Chester then back to Paradise. About a 130 mile round trip. When I got to Chester I noticed my engine rpms were at 1900 they wouldn't come down for shit. This happened five times on my way home. Now I've checked everything except the maf and brake booster for a vacuum leak.

 

I think I jinxed myself... went to drive off after my alignment and the steering was responsive but something felt squirrelly about it. Immediately pulled back in and told them something was wrong. I bet they didn’t tighten the cams bolts enough and shit was just sliding around. This is what I get for trying to get a quick alignment before the end of the day.