What Have You Done To Your 2nd Gen Tacoma Today?

Has any one done the chopped exhaust mod. My truck came from the dealership with dual exhaust exiting behind the rear wheels and i don’t like the look and i am afraid i am going to smash them on the trails! I am thing about cutting them off just above the rear axel, but i am concerned that the fumes my leak back to the cab.

 

I had a shop cut mine just after the last hanger and weld on a down tip



No more dorky pipe hanging out the bedside

and zero vibrations as the pipe is still solid mounted

 

You can find on Amazon or Ebay...mine fit a bit loose so put a little smidge of silicone sealer on knob before installing.
I got the 4pack w/4x4 knob.

 

That’s exactly how i was thing of doing it. Probably going to take my sawzall out this afternoon and do it!

 

​

 

Do tou have a link? Also pic's of 4x4 switch installed

 

Hop over to the +50 thread and you will see a real chatty bunch just having fun...

 

is the 50+ thread the little coffee shop at 5am of threads?

 

Looks good at night with the backlit knobs....gives ya that warm fuzzy feeling.
https://www.ebay.com/p/4pcs-AC-Car-...-Tacoma2013/2194854745?iid=322971624929&rt=nc

 

Could i get some details on your cb and how you installed it! I am looking to do something similar. I even looked at the cobra that had all the controls in the mic and a box you could mount under the seat. I like the look of your set up

 

The remote ones are pretty cool...I installed a

$40 Uniden Pro505XL 40-Channel CB Radio. Pro-Series, Compact Design. Public Address (PA) Function. Instant Emergency Channel 9, External Speaker Jack, Large Easy to Read Display. - Black

Uniden Pro505XL...basic & small, didn't need anything too fancy for trail coms with a Tram mag mount antenna (for now). Had to measure and drill a hole in the back of the cubby to fit coax and wiring through and small screws to mount bracket as far back under dash as I could. Hard wired in and "breaker breaker good buddy"!

 

Does it interfere with using the cup holders at all?

 

Big Yeti types...yeah...water bottles and other stuff a little but not too bad. If I was to do over and had the $$ I'd get the remote unit and mount the coax in one of the dummy plugs. Hindsight.

 

Not sure it would fit Amazon has the size at

 

Usually the size they list is the size of the box it comes in. Not the box it's shipped in, but the packaging.

 

This makes no sense for a person ordering over the internet! So it must be true!

 

Easy just figure out where you want to cut, run a piece of tape around it for a guide , and lop it off with a sawzall or cutoff wheel

 

That is a clean underside

 

Mine is 5" wide, 7" deep and 2" tall.

 

Ha I try to keep it that way this was taken right when I did my lift and I cleaned and painted everything as I went. It's all white with salt now