What Have You Done To Your 2nd Gen Tacoma Today?

Almost done with my switchpro install extravaganza! I ran out of ring terminals so I gotta run to the store, but it is 95 percent finished. Super pleased with how clean it came out too!

 

What’s the details on that comm gear you have there?

 

You have them on upside down, flip them over and the plate goes on the bottem, then you slide the bumper just under the u bolt. See if you can blow up this pic hope this helps!

 

You two have different types of U-bolts.

 

Shit just noticed! I got new ones with the new springs, stock ones were the same shape tho not sure why his are round.

 

This orientation looks correct. You got the u-bolt flip kit right?

 

This looks like something I'd smash on a rock the first time I went off-road.

I like my stock knobs. Easy to tell what position they're in without looking at them.

 

Yaesu ft7900 with the body and speaker under the seat. The face fits perfectly in the pen tray.

 

Apparently you have a U bolt flip kit. IDK if I'd reuse the U bolts personally but to each their own. To reuse your stock bumps you may have to find an alternative wayto mount them like drilling and tapping the plates and bolting them down to the plates. Or, you can order a set of super bumps from Wheeler's hell you can order a new set of Ubolts for the flip kit from wheeler's for like $20. The setup the other member showed you was stock configuration

 

if its AVS they guarantee it, against breaking!

 

Even at 5 years old and 1 degree out?

 

I’m still waiting on my sticker from @tcBob.. hoping it arrives soon

 

as far as i know, i closed my hood 1 day in winter & the end just snapped off, i was shocked, they had me mail in a little section with the avs logo & they sent me a new one

 

Should... I found out he sends all @ once of tacomaworlders fill s list lol

 

Oh. You're being serious.

Well.....um. I snapped it in half so it would fit in the garage can.

 

Reported

 

This. Get new hardware.