Norcal Spotted and BS Thread

Sorry, no T&A on that one. Going for humor only.



.
.
.
.
.
.
.
.
.
.
.
.

 

I'll be doing just that this week end. Have all the parts now. Will report back when finished.

 

ooooohhhh myyyyyy.

 

i have these battery terminals, i have no room to add an 8 gauge nor a place to ring terminal to throw on each time i want to air up. My accessory fuse panel would not support the draw from the compressor or i would run a wire from that to the back.

 

I was just saying you could hard wire the plug to the battery and zip tie it to something for security. It has a cover to eliminate arcing.

I’m not going to use the connector kit in my garage. I’ll just drop it off at your work tomorrow morning. If it won’t work, just throw it towards my front door on your way back from Starbs

 

I ordered these. I'll tell you if they're any good when they arrive.

 

Oh, and I ordered a couple of these, as well.

 

Link?

 

Link?

 

...get in line!

 

I hear ya and im going to look into running a specific 8awg wire from the battery to a plug that supports it and wire the opposite on the compressor. I just need to think how because my lack of available space in my terminals.

Those should work fine, mine are already installed and ran and whatnot so i wouldnt want to change my set up again.

EDIT: just looked into my accessory panel and it can hold an 8awg and circuit allows its amperage. So that makes things a lot easier. Little 8awg wire to the trolling motor plug and boom.

Thanks for the help all.

 

ok, ok... Uncle Google says

$25 BenShot 'Merica Rocks Glass with Real .308 Bullet - 11oz | Made in the USA

https://www.amazon.com/BenShot-Merica-Bulletproof-Rocks-Glass/dp/B01M32WOJB

 

Sounds like y'all just need a battery with dual terminals.

 

All that talk, but no listening @LTDSC

Look pretty good, but I wonder if they will end up too close to the hood once a bunch of rings get stacked on them? I used the basic MIL terminals on my first gen when I installed my 7-pin, and found that I had to spend some careful time orienting and stacking various ring terminals to keep it all compact and low and fit under the terminal covers..



Edit: terminal part #s for kicks

 

sam it sounds like its time for something like this

MICTUNING 12-Slot Relay Box,6 Relays,6 ATC ATO Fuses Holder Block with 41pcs Metallic Pins for Automotive and Marine Engine Bay

https://www.amazon.com/dp/B075M4PRG...Hz&pd_rd_r=GYDECQVG9QKGKTQP9EWE&pd_rd_w=iX6yc
or have iggy help you out.

 

i have one already. I just didnt realize it supported over 30amps per circuit. So all is well now.

 

must do, I saw a few that don't.

 

$40 BenShot 'Merica Rocks Glass with Real .308 Bullet - 11oz | Made in the USA [Set of 2]

https://www.amazon.com/BenShot-Meri...83&sr=8-8&keywords=benshot+bullet+rocks+glass

 

@Overlanerd

Here’s the beam pattern. Beamed once so far and the driver side lights up road signs on the other side of the road.

 

With the exception of the door they shorted me on, the kitchen is friggin done.

8 days of work, so glad it’s over.

From this:



To this: