What Have You Done To Your 2nd Gen Tacoma Today?

Softopper seemed to have more options of add ons

 

For me, yes. It takes no time at all to fold down whereas with the besttop you need to remove the side windows before you can fold it down.

 

Ok, I'll have to do a bit more research of the two, Thanks for your input!

 

So what I have found is that Bestop has no options other than tinted windows, were as Softopper has the ability to make it a tent as well as a mesh back window and multiple colors. So I think that I have made up my mind and I'm going to buy the Softopper, over all it just seems better.

Again thanks for the input!

 

Punted some rigid side shooters on relentless brackets

 

Might want to angle them more to the sides! That hood glare can get pretty bad. The SS’s are great btw

 

Hey there, mine too down here in Little Rock. Road were fine, tho.

 

Installed the pure Bluetooth GTA kit in my 2006, works great. Paired with my IPhone with no issues.

 

It didn' rain on me but I did the same today. New to me Bestop. I'll put the windows in tomorrow when it's warmer.

 

Looks good. To get the side windows in I had to unhook the cover in the rear corners. Slide the windows into the j-hooks at the top. Then zip the front zippers and pull everything to the rear as much as you can. Then zip the rear zipper and re-attach the rear corners to the side rails. I couldn't get the front zippers to go together when I zipped the rear first.

 

Finally got around to doing my cab mount chop for my 33's.

 

I'd have to remove the side skirts in order to do it. Lol





Btw, pic was taken in a Walmart parking lot

 

Pic at walmart thats ironic. I'd lift it and put it on 33's to

Good looking truck also BTW

 

Yes it was at a Walmart parking lot. My wife works there. And thanks

 

It's gonna be mid 70's today. I'll let everything warm up. Thanks for the input, as I'll try it that way to make it easier.

 

Finished up my radio/dash/console bezel install. Also fixed the temp/compass with some solder.
Thanks @gunny1005 for helping with interior parts.

 

Before I go and silicone the outside of these lights later this week, can someone verify I’m going to silicone the correct seal?

 

Get one of these. It does everthing.