Great White Taco build

@stairgod (#Mohawk Fab) built this for me. He tested the one he made for himself. Only effects travel when both wheels are off the ground (AKA a jump) Stuff and droop are unaffected. I’m not planning to jump anything...

 

i was trying to imply more so when the trac bar is against the rock not letting the rear come down fully where a two piece would have a slight advantage. i can think of a few situations ive been in where that would have been the case.

 

Ah, I see. I figure this Trac Bar has saved me a few re-tubes at this point. One piece or two, I like having it.

Last time I bent a DS, it was so bad, it was hitting the center bearing mount as it rotated lol.

 

@fatfurious2 Big reveal still tomorrow?

 

no, not tomorrow.

Its arriving on Monday. I decided not to take off work, and just wait until Wednesday to pick it up on my day off.

I ordered a car, and its being transported to Winchester

 

haha. Like I said, just a guess
For some reason I thought you said it was thursday. Guess we shall wait another week then.

 

yea.. just one more week. Is what Ive been telling myself for the past 8 weeks

 

Its en route to Roanoke VA. So the eta for Monday is still on track!!

 

Check it out David. I found my fender cutting specialty tool

 

looks, uhm, very special indeed

 

It got the job done

 

Thanks! Now that winter is over, I can make my own and start getting ready to do this.

 

I’m sure you know this already, but the cut line will be the measurement from the top of the bottom hole to the center of the top hole.

 

Winter was not over at Rausch yesterday though. My winch got a workout getting @Mobtown Offroad unstuck from 21.

@DoubleRGirl

 

Great white sighting...

 

That makes sense. You did 2" ?

 

I thought I did. I just measured it though. 2-1/8”. Drill probably wandered a bit when I made the holes.

 

I've talked to a couple people. Maybe up to 2.5"

 

Ryan did 3”