What Have You Done To Your 2nd Gen Tacoma Today?

Got the Wheeler's Progressive AAL installed.

 

Yes. I specifically redid the original design so that it would work with BPF and the Toyota TRD accessory skid plates. The design hugs the bumper close so that it fits between the bumper and the skid plate. Here is a picture from a customer who purchase one, and a link below to his post in the sale thread.



https://www.tacomaworld.com/threads...racket-35-shipped.429680/page-4#post-12676129

 

Cool. Good to know. I may just get it before I get pulled over.

 

885 with wheelers progressive add a leaf and 5100s. Demello flat top will be here next week! Here’s really hoping I won’t need UCAs yet and that the 885 can hold the new front. When I ordered it all I had read enough to think I was ok. But I’ve since read way to much and now a little nervous about it. Here’s hoping it’s all good!

 

No. It's red.

 

Sparkplugs, tire rotation, greased everything an ultimate headlight upgrade an oil change. Driver side upgraded passenger stock that beam difference is emmence.

 

How many miles on those plugs?

 

12k been running cheap gas these were ngk went denso this time. Just did the plugs last year at 50k had a misfire code.

 

Warmed up to ~50 degrees in Michigan today so the Taco got a wash.

Also put the center console organizer in and dig it so far

 

You get the Steel or Aluminum Version? Aluminum weighs 55lbs and Steel is 120lbs. Going to assume Steel and add the weight of a winch another 60-90lbs or so. Yeah you might want to get the 886 springs.
If you got the Aluminum, after the 885 settle a bit, might want the 887.

 

There it is!!!

 

I got steel. They told me it was like 103. I’d like to get some skid plates but prob won’t get a winch until my current toyos go bald. Then I’ll go 886 with 33s. Not looking for 3 inches even. So if it says to 2.5 that’s ok. Right now I have a spacer and block that was On when I bought it. It sits 23 front and 24 rear. I’d like to stay close to that.

 

Difficult??? Looking to do the same thing

 

Love those headlights. Custom?

 

It's pretty easy, just take your time, and if you go with wheeler's just follow their directions. Hardest part is lining up the leafs to get the bolt back in, and that just takes a little bit of time.

 

Sweet headlights!!

 

Love the headlights are those retrofits or you just painted the inside?

 

Great idea.. always bitching about not having a place to put my vape without it laying on its side

 

Got ol Betsy washed today!