What Have You Done To Your 3rd Gen Today?

Any issues with the install of the waterport? Think that's my next purchase since summer is coming... that and tint.

Also, if i saw correctly, you painted it in a later photo. Any issues there? Might be cool to paint mine too just for fun.

 

Just got mine cleaned today

 

Where is this bumper from? Looks mean, reminds me of my 4X4 Labs bumper on my 4Runner.

 

Looking good! That’s a mean looking mofo you’ve got there!

 

It's made by CBI fabrications . It's a full hoop T3.

 

MobTown Skid

 

Hell Ya. I'll put it on the "back on the mainland" list. Love CBI.

 

From the picture it looks like a lot o that is paint transfer to me... try wiping it with a little paint thinner or some acetone. Some of its through the paint, but might make your decision easier to fix or not.

 

Too expensive to repair over-and-over again. This is the solution as I did and very happy with the new bumper:

http://fabfours.com/product/premium-rear-bumper-14/

 

Tell me about that light bar. Is that mounted with an OEM roof rack?

 

Damn, this is a nice looking truck!

 

couple things to finish up still but everything is in and operating as intended. total cost with everything in is about $200

 

Looks great, nice job

 

Cleaned some corrosion off my negative battery terminal and installed HPS Silicone Air Intake Tube (57-1600) with TRD Intake Flow Accelerator (PTR03-35160-AE). Throttle definitely a bit more throaty, will see if I notice more once it settles in.

 

Call a paintless dent repair person they may be able to fix the dent for much less.
Also I damaged one of my bumper caps and I put a message in the 3rd gen buy sell trade WTB bumper cap and got one shipped for $70 from a tacoma world member. Touch up paint on the fender flare. And a little scratch remover

 

Yes it is, i just moded the brackets that came with the light bar to install it that way

 

No issues so far with the waterport. I haven’t used it yet only to test it. To cold here in Ohio right now to leave water outside. Haha.

Not sure what you’re talking about painting?
They come in Black now.

 

Ordered a bunch of stuff including a new brake controller (redarc tow pro elite), some misc stuff for the amp and sub, blah blah. Need the controller.

 

Are you clearing the cab mount with that setup (wheels/spacers)? Tried the same setup.. No go.. Need to chop the mount.

 

thanks. got a few more wood pieces to make to finish it off. waiting on the wheels for the center support roller.