License plate light plug type?

Does anyone know the plug type for the license plate light (left, driver side). It plugs into the the following:

Not the light bulb side. The plug socket side opposite of the bulb with the 2 prongs in it.

Thanks.

 

I think I have the PN at home, I'll check and update later.

 

@raksasas sorry for the delay. Toyota PN

$19 90075-60005 Socket Plug

90075-60005 they cost me right around $9 each. This is just the connector so you have to identify the polarity and solder in leads.

 

Drainbung, thank you for responding it is much appreciated but I am not in need of the part pictured above. I need the other side that plugs into the part pictured above. If it plug as a name that would be much appreciated, too.

 

You will find this part number as

$9 90980-11162 MOTOALL Turn Light Signal Harness Cable Connector Fits for Toyota 90980-11162

90980-11162

 

Is there anything I could use if I wanted to plug into the license plate lights and have a two wire pigtail come out that I could use to power another set of lights? So, basically delete my license plate lights and run another set of lights I could put a switch into by plugging something into the socket the bulb goes into. I wanted to maybe set up a light or two in my camper and dont care about losing the license plate lights. thanks

 

The PN I posted is the plug-in to that socket.

 

Anything?

 

Have you verified that by searching google or ebay for that part number?

 

Don't have to. Those are from the parts I bought at the dealership.

 

So.... pick 1
1. Your dealer is right and everyone else on the internet is wrong.
2. You are mistaken about what came in the package you just dug up.
3. The part you bought was in the wrong package.
4. The new guy in this thread posted the correct part number.
5. You are so confident that your number is correct that if the wrong part shows up, you will personally reimburse the OP.

 

As @6 gearT444E said, Toyota p/n

$9 90980-11162 MOTOALL Turn Light Signal Harness Cable Connector Fits for Toyota 90980-11162

90980-11162 is the number for the connector that mates to the OP's license plate bulb plug. You'll have to add terminals or pigtails, 2 x

$14 82998-12440 Genuine Toyota Parts - Terminal, Repair W/W (82998-12440)

82998-12440 will get terminals crimped to 160mm of wire from the dealer.

 

Good job. I was able to find the connector number, but wasn't able to find the pigtails. Do you have some magic source for determining which pigtails fit which connector?

Here is a chart that shows the connector numbers.

http://www.customtacos.com/tech.old...oyewd/06toypdf/ewd/2006/tacoma/l/em01d0up.pdf

 

LOL WTF is that?

 

Isn't a license plate light required by law?

 

Those are the plugs that correspond to the PN I listed.

 

No one argues that those are

$19 90075-60005 Socket Plug

90075-60005. But whoever did that used them wrong.

 

This is a Toyota

$9 90980-11162 MOTOALL Turn Light Signal Harness Cable Connector Fits for Toyota 90980-11162

90980-11162 made up with two

$14 82998-12440 Genuine Toyota Parts - Terminal, Repair W/W (82998-12440)

82998-12440 repair wires. See how it mates to the correct side of the lamp holder?

 

You can make up a correct plug that looks like the connector end of a lamp holder using a 90980-11168 housing and 2 x 82998-12430 pigtails.