I can’t make up my mind :(

ok so I have this ready to go. 1/4 spacer on passangwr and 1/2 driver for the lean and to get full 3 inches up front thought about fox 2.0 but I like the idea of a whole new leaf pack being that mine are shit

 

Looks good. The top plates headstrong uses might have longer studs already. I would call tomorrow and ask.

 

If they don't and you have to install them then skip the assembly.

 

Wait?.... didnt you just have another thread going about this?....

 

Ok my other concern is it says the leaf springs are 2.75 of lift and I feel like there will be a ton of rake. These decisions are so hard to make haha

 

Yes....yes I did. I’m more indecisive than asking where to take your gf out to eat.

 

Call headstrong tomorrow or pm Marie. @HeadStrong Off-Road , she will set you straight.

 

I need someone to just tell me what to do or I will never make a decision so that’s probably a good call. I’ve been stuck on the 6112 kit for a few months so that’s probably my route but the fox kit is enticing. I just need to leafs so it makes more sense for my budget

 

I think with 1/2” spacers you’re gonna be above 3” lift on the 5th setting.

 

Says they are 2.5 maxed out and with taco lean they recommend 1/4 spacer so I figure 1/2 will bring me level plus the extra to get to 3inches?

 

Do it, do it, do it. Place the effing order and call tomorrow.

 

That’s just what I needed.

 

Place the order.

 

And stop making so many duplicate threads.

 

Should I make a thread about not making threads anymore?

 

You can change the title to reflect your indecisiveness.

 

Yes but it should go in the general discussion area.

 

This title better?

 

After all this hand holding and codling I expect photos of truck was it's all lifted.

 

1/2” spacers will give you 1” of lift.