What Have You Done To Your 2nd Gen Tacoma Today?

So today on my 2nd gen Tacoma I did nothing except fixate on what I think is a drive line vibration. About two weeks ago I installed an OME 3" lift, LR UCAs, and a carrier bearing drop kit. Also upgraded to a used set of 285/70/17s. Any ideas of what it could be? Some key notes that may rule a few things out.

• I didn't notice the vibration before the tire upgrade, but that could be because of time also. Anyway short of swapping tires to know if that's it?
• I have checked all components torque value at least three times.
• It seems to go away with up travel on a bump in the road, but comes right back.
• I only feel it in the pedal and nowhere else.
• I have already installed the ECGS needle bearing. The vibration feeling didn't start until after the lift /tires.

 

All set up for camping (again)!

 

So i have after market rims and tires and a leveling kit and some times at low speeds (20-30 mpg) i “think” i feel a vibration in the pedal. Wife thinks i am going crazy!

 

He used lag bolts through the chassis. If you're interested in actually doing it his post in the thread is here.

 

Full Proline Plasti dip today... silver matte. Finished 2005 to 2015 conversion.

 

Not exactly perfect for this thread, but it does relate to my Taco since it got me to the airport and then sat in the garage all week.
I went to Manchester NH for a job and promptly ran into a blizzard. Good thing my rental was a bad-ass Toyota.
So what did I do to my 2nd gen, well I traded it on this for a week.

 

That's where I think I feel mine at. My wife says the same thing, but she's been saying that since we started dating haha

 

I think the only issue you might have is if the 6 gauge lugs will physically fit over the 4 gauge wire or not... If they fit, I don’t see any issue.

 

That’s a sweet bumper! I need to look into something like this as mine has cancer...

 

Pics for the guy who asked how far it sticks out

 

Do it !

 

I just got these today. Now I need to decide what to put them on.

 

I had a similar issue. It turned out the be the needle bearing. Here is a thread that might help.

https://www.tacomaworld.com/threads...differential-bearing-vibration-thread.152173/
If that is what it is there is a TSB on it so mine was fixed for free by the dealership, I have not had the problem since. (bout 15k miles since the change.)

 

Nice looking LC.

 

Sorry, I should've mentioned I already changed that awhile ago. I'll edit my original post.

 

O like this but this a what did you today thread? So what do you do?

 

Which Speakers are they?

 

Yea they fit they’re not super tight on the wiring but they don’t leave much room around it, it’s snug. I don’t have to force them on or off.