What Have You Done To Your 2nd Gen Tacoma Today?

Picked up my new @Pelfreybilt bumper this morning. That is this weekend's project

 

I forgot to take a pic while it was still loaded but I hauled my mil's Kia Sedona for about 30 miles.

 

So I finished my rear TRD pro shocks. Now I’m hoping when the dealer changes my leafs I will gain 1 1/2” - 2” because I have a major laid back truck now. Didn’t think I would gain so much in the front. Did get an alignment today and it came into spec easily.

 

Lag bolts. the safe comes with pre drilled holes. Put the safe in place, checked under truck for obstructions and drilled straight through the chassis.

 

I've got alpine SPS-110TW tweeters, Rockford fosgate Prime

$90 R169x2 6"x9" 2-Way Full Range Coaxial Speakers (Pair)

R169x2 in the front doors and

$80 kicker 43DSC6504 kicker DSC650 6.5" (160-165mm) coaxial speakers, 4-ohm (pair)

kicker 43DSC6504 6 1/2" speakers in the back.
I had the alpines laying in my garage for years and the Rockford and kicker I got based on the price and the watts they put out.
Everything sounds much more crisp now even with the stock head unit you can definetly tell a difference between these and stock. I'm surprised the stock ones can do what they do based on the way they look and how light they were

 

Got my ATO hilift mounts and got it all set up. Fits the 60" hi lift perfectly in short bed.

 

Lift finally dialed in.

 

Shaved down the spacers in the prinsu and pulled the headliner and put the bolts up from the cab.
Those rivnuts are a pain to get out... I’m glad I did though because not all of them were seated properly, now everything is nice and tight. Plus I re did the derp on the roof to prevent rust.

The gap I got rid of wasn’t large and something no one would probably notice, but it bugged me every time I walked up to the truck... so today was the day

Before

After

 

I’m leaning towards the pro suspension.

 

Smart ass

 

I ended up getting the Powerstop drilled and slotted brakes and I absolutely love them, the ones you have are almost identical. Hope you enjoy them!

 

Morning mimosas via Tacoma!

 

Same here. Gotta love that Amazon price mistake!

 

I mounted a magnet bar to the top cubby screws. It was a little long so I used a bracket I had in my junk drawer. I figured when I use my tailgate for a table it'd be a good place for utensils.

 

just to make sure everythings ok...this is just moisture right? and the engine not getting hot enough to evaporate it? fingers crossed

 

That actually looks like a good place for permanently mounting utensils. What's the worst that could happen driving around with that knife on there all the time?

 

That is a sign that it's time for a road trip.
You are right. It's only condensation from not warming up enough.

 

This cold damp Southern WV weather doesn't help either plus 4 days a week to work at 6 am that is only 5 minutes away doesn't give it much time to heat up lol