BORA .75" spacers

Has anyone installed these on a 3rd gen? If so, did you have to trim your existing studs? I'll be running these behind stock OR wheels and do not want to cut studs.

 

I'm pretty sure your stock wheels have pockets in between mounting holes that are deep enough for existing studs, so no need to trim. My sport rims do have the pockets.

I'm going to run the 3/4", or 1" spacers on stock rims on my sport also, after TRDPro lift like you installed, Monday.

 

IIRC 1" is questionable for trimming studs and 3/4" was mandatory stud trim/grind.

 

With aftermarket wheels, yes need to be trimmed/grind down. With factory wheels pockets are deep enough. Factory studs stick through 3/4" spacers only 1/8" to 3/16" There is a picture of it in a posting here, if you search 3/4" Bora spacers.

The picture, I'm referring to is in posting. Caution: Before/When Installing .75 Spacers Check OEM studs. 1st page picture of this.

 

Will depend on your wheels. I have Bora 3/4” spacers and did not have to modify the studs with Black Rhino Sidewinder wheels.

 

I have 3rd gen wheels on my 1st gen with 1" BORA spacers. No trimming was necessary.

 

I messaged a fella on this forum that is running Bora 3/4 inch spacers with TRD OR wheels>He said no trimming needed there are pockets on the backside or the wheels that allow them to work.It was Marcoc in CT.

 

Thanks everyone! I contacted BORA and they confirmed no trimming required with stock OR wheels.

 

What tires you going with?

 

I haven't decided yet. Just going to run stockers, until I can make up my frick'n mind. Either Terra Grapplers, KO2's. Have had TG's a few trucks and good luck with them.

 

-
I'm putting 255/85-16 on as soon as I get my spacers

 

That's a scary post there

 

Those will look good on your truck. I will go with 265/70/17, or 275/70/17.

That's what I thought also, when I read it.

 

lol...... you guys are fussing about 3/4 in spacers? im running 1.25" spacers anf direct bolt on..... sexy af with oem or wheels and falken at3w 285-75 R16.... lol

 

Just confirms, my reason to stay with .75 spacers. Don't want my wheels/tires to stick that far out. Thanks for the pic.

 

I wonder if any trimming is needed for the 16" TRD pro wheels. Has anyone tried?

 

OP did you ever get them mounted? Any pics? I’m trying to see how far they push the wheels out

 

I like the way that looks. Do you have any more pictures at different angles?

 

Have you installed the 3/4 spacers? ...any pics ? I also have a TRD Sport Cement Gray and wanna do the same thing.

 

Late reply but I have 1.25 s I'll post some pics up later for ya