AZ BS thread...

Just got a sample from the shop. The white is going to be clear...


What do you guys think?

 

It looks great!

 

Can't decide. The white square has to go for sure.

 

Looks awesome man! Excellent work! I'd totes rock that.

 

Sucks to be this guy...

 

X2!!!

 

Nope...but that's what happens with a rookie gets a fast car.

 

Damn that sucks... they should put all officers through the Boudrant Racing at Firebird IMO...

 

Hell Yeah!! I'd go EVERY weekend!!

 

Heh if I got it paid for I would too

Seriously though, aren't each of those cars at least about 80k a piece after mods? Seems like a few grand in lessons would save some overhead to say the least.

 

Hey Pinal... just wondering if it's true you can no longer have a full plate cover that's transparent in a month? Just got pulled over for a 'dim' license plate (one of the bulbs fell out of the socket and was behind the bumper I found when I got home. Probably loose from the start when I swapped lol). He was nice about it but it was kinda.... weak lol.

 

That looks great man! Just get the white stuff clear and its perfect!

I want 2...one for each corner of the rear windows of the Taco!

 

Is that the final selection ?

 

I believe so...except the white stuff will be clear and all clean lookin

 

woohoo looks good!

 

I'll pass, I don't like it.

 

According to Arizona Revised Statutes 28-2534 B and B3, the plate has to be "clearly legible and visible". As far as the plate cover, I have to be able to clearly see the plate at all angles. The reflective "anti-photo radar" plate cover often obscures (duh) the numbers in which I can't clearly see them at certain angles.

ARS 28-2534.
A. A person shall display the license plate or plates as follows:
1. For a motor vehicle, motorcycle, trailer or semitrailer, on the rear.
2. For a vehicle for which two license plates are issued, the vehicle owner shall display either of the following:
(a) One plate on the rear.
(b) One plate on the front and one plate on the rear.
B. A person shall display all license plates as required by subsection A until their lawful use expires or is canceled or revoked. A person shall maintain each license plate so it is clearly legible. A person shall securely fasten each license plate to the vehicle as follows:
1. To prevent the plate from swinging.
2. At a height of at least twelve inches from the ground to the bottom of the plate.
3. In a position to be clearly visible.
C. A person shall maintain each license plate so that the name of this state at the top of the license plate is not obscured.
D. A peace officer shall not stop or issue a citation to a person operating a motor vehicle on a highway in this state for a violation of subsection C of this section unless the peace officer has reasonable cause to believe there is another alleged violation of a motor vehicle law of this state.
E. If a person violates subsection C of this section, the person is subject to a civil penalty of thirty dollars, except that if a person violates subsection C of this section within twelve months after the date of a prior violation of subsection C of this section, the person is subject to a civil penalty of one hundred dollars.

 

Stuff for Sale Send me a PM with any questions


Icon Vehicle Dynamics Extended Travel Front Coil overs and Camburg Fabrication 1.25" Uniball Upper Control Arms, 10 months old - $1200 for the package ($800 for coil overs $500 for UCAs separately)
10.5" travel, fully adjustable from 1-3.5" of lift, Upper control arms replace stock and allow for maximum travel and proper wheel alignment.

Deaver J66 1.5" lift leaf springs, rebuilt in December of 09- $350

8.4" Toyota Third member with ARB Air Locker and 3.73 gears installed in January by Desert Rat Off Road- $900 (includes warranty)

All Parts will be available June 6th

 

Done with finals!

 

Nice man