SOLD Bilstein 6112's

Used for about 6 months and roughly 8,000 miles; they're set on the 5th notch (out of 6), and a 1/4" spacer for the driver side to help with the taco lean.

SOLD

Note that I should have the 5160's available in 2-3 weeks as well.

 

How much lift did you get out of them being on the 5 notch? Since they are 2nd gen 6112.

 

These are the 3rd gen version, they have 6 notches, I'd just opted to use the 5th (part number 47-234413). It was still around 2.5", when I first installed I put both on 6 with 1/4 spacer on driver side, and it was nearly 3"; that was when I took them down to 5th notch.

 

How much would you sell these and the 5160s for as a package

 

Yeah same question how much would you sell with the 5160s as a package? And if In Cali? Pick up?

 

Say maybe $600?

 

Located in Michigan

 

How was the ride on the 5th notch? Comfortably stiff or uncomfortably stiff?

 

I'd potentially be interested in the 5160s if the price is right when they go up

 

Online it says the 6112's get up to 2 inches only. How were you able to get it up to 3 inches?

 

I think they are under estimating the potential lift heights, or perhaps expecting it to settle some (though I didn't notice much settling). They also recommend a max setting of 6 driver and 5 passenger, whereas I originally had them both set on 6, with a spacer on the driver side for the lean (originally, it wasn't long after that I took them both down to 5 with spacer on driver side).

 

Gotcha, that makes sense. How was the ride at the 6th notch?

 

It was definitely stiff with both on 6! I actually think it was still a little too stiff on 5 for my preferences, but I liked the look of the stance where they were at, and while the ride was still on the stiff side, they did handle great. I'm sure adding a bumper and/or winch in the front would have offset it and rode much better.