TRD Pro & TX Baja OFFICIAL Thread...

Im with you on that

 

I’ve got an arb bar which weighed in around 130. The springs hold it just fine but I have a bit more body roll than I’d like. I ordered a set of 700 lb springs for mine. As far as height goes, you can always add the coil seat spacer from toytec to get an extra inch if you start to sag.

 

You know what your hub to fender measurement is? I'm hoping to be able to use the 600lbs Pro springs. Mostly i just bounce around in the pasture pulling up fence posts and the tractor out, when she gets stuck. Excuse to the wife get the winch, lol

 

I’m running icons, 650lb and have a 23” hub to fender measurement. I’m aiming to keep the same height on the 700s.

 

I see. Thanks. Thought you were running 600lb Pro springs.

 

Progress... the only thing changed was the holes for the bolts. We tightened them up a bit since the holes on the first ring were too big. I requested one scallop to be removed and the others adjusted, but we'll see if that ever happens lol.

 

Let me make sure these wont fly off during testing first I had to special order hardware online, couldn't find it anywhere locally

 

Them gonna look bad ass son!

 

Checked them but they had limited selection and they were the round allen head bolts only. I found this place that had regular hex heads and got them zinc coated. Should be here tomorrow

 

I just installed the TRD Pro suspension on my truck, don't suppose anyone knows if the alignment is any different from a TRD Off Road? I'm also assuming a little more height in the rear shouldn't have any bearing on the front alignment?

 

What's that front bumper/winch setup you have?

 

I wouldn't think the rear would as they still remain straight regardless of elevation. Normally its the slight change in height dimensions for the front that calls for an alignment as the suspension changes slightly.

 

Thanks for the offer man but my order got cancelled and I've had no luck finding another.

 

No problem bro. If u need em let me know.

 

Even camber
-0.05 ish cross castor
Stock spec toe in

 

US Off-road and Smitty x20.

Found bumper vender on TW. @usoffroad
Freaking love the bumper and their powder coat is the shit. Has held up better then I ever expected. Highly recommend. But, if doing 5100's and want height, get some ome coils or the pro setup lol

 

what wheels do you have? those are sick af

 

SCS , Ray-10’s in brushed copper

 

Hardware arrived today. The bolts were a bit too long as expected, but the thread pitch was right. Going to have to cut each one down. I also need to figure out what color to paint them or seal the raw metal (which I know will eventually rust)

 

Looks good
I say brush them and Clear coat !